P/N 064218-005
TRAKKER Antares 2400 Series Belt Clip and Belt
Instruction Sheet
The belt and belt clip allows you to have the TRAKKER
®
Antares
™
2420 or
2425 terminal hang at your side so you can have both hands free. The belt
clip snaps around the belt and a Velcro strap holds the terminal to the belt
clip. With the terminal at your side, it is easy to reach when you are ready to
resume using it.
To attach the belt clip
F5
Fn L
A
B
C
DE
F
G
H
IJ
K
L
M
NO
P
Q
RST
U
Z
VWXY
Fn R
Enter
8
9
5
6
1
2
0
3
Tab
Esc
Velcro
surfaces
Buckle
slot
Flap
242XI.002
Slot
1. Slide the belt clip flap over
the belt and snap the flap
closed.
2. Buckle the belt so it is snug
yet comfortable with the belt
clip resting on the outside of
the thigh.
3. Thread the Velcro strap
through the slot on the
bottom case of the terminal.
(If you have a handstrap on
the terminal, you may need
to temporarily release it.)
Pull the strap through the
slot.
4. Thread the Velcro strap
through the buckle slot and
press and rub the two ends
of the Velcro strap together
until they lock and secure the
strap.
If you need to temporarily remove the terminal, squeeze the buckle to release
it. To reattach the terminal, simpl
y
snap the buckle ends to
g
ether.
6001 36th Avenue West
P.O. Box 4280
Everett, WA 98203-9280
© 1998 Intermec
All Rights Reserved
P/N 064218-005
-
1
-
2
Intermec Trakker Antares 2425 Supplementary Manual
- Type
- Supplementary Manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Intermec EasyCoder PL4 User manual
-
Intermec Trakker Antares 2420 Accessory Manual
-
-
-
-
-
-
-
-
