The handstrap (P/N 825-196-xxx) provides you with a convenient way to carry your
PW50 printer. The handstrap kit contains these items:
• Handstrap accessory
• These instructions
To attach the handstrap
1 Release the strap from the adjuster, and remove the strap from the VELCRO
pad.
2 Insert the strap through the PW50 and VELCRO pad. Make sure the D-ring and
adjuster are oriented as shown at the top of the PW50.
PW
50
Handstrap Instructions
Note: VELCRO is a trademark of Velcro Industries B.V.
Strap
D-ring
Adjuster
VELCRO pad
Worldwide Headquarters
6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel 425.348.2600
fax 425.355.9551
www.intermec.com
©
2008 Intermec Technologies
Corporation. All rights reserved.
PW50 Handstrap Instructions
*943-159-001*
P/N 943-159-001
3 Place the strap on the VELCRO pad, and route the strap through the adjuster
and D-ring as shown.
4 Close the VELCRO pad over the strap. You are now ready to use the printer with
the handstrap.
5 (Optional) Install another handstrap on the other side of the PW50.
Strap
D-ring
VELCRO pad
Adjuster
-
1
-
2
Intermec PW50 Operating instructions
- Type
- Operating instructions
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Intermec PW50 User manual
-
-
-
Intermec PB50 Supplementary Manual
-
-
-
Intermec 850-577-001 User manual
-
-
-