Bathroom Faucet

With Pop-Up

Before You Begin

Check to make sure you have the following:

Troubleshooting Guide

Minor problems often can be fixed without a plumber. Before doing any work on the faucet, shut off water supply and

close stopper or drain to avoid losing small parts.

noituloSesuaCmelborP

Leak from spout Damaged or dirty seals Disassemble faucet, remove cartridge. Clean or replace

Water drains slowly or not at all Clogged drain Remove stopper. Remove visible debris.

If still clogged, remove and clean trap. Reassemble.

Replacement Parts

Keep this manual for ordering replacement parts.

10115LF

10116LF

Tools and supplies that will help simplify the installation of your

new faucet:

adjustable

wrench

basin

wrench

supply

lines

tube

cutter

pipe

wrench

hacksaw

1 Shut off hot and

cold water supply to

faucet or turn off main

water supply.

Removing Your Old Faucet

6

With the ball rod all the way

down, push the tip of the ball

rod through the lift rod strap (2)

until it is aligned with the lift rod

(1).

Thread lock nut (6) from under-

side of sink until rubber washer

sits securely inside opening of

sink. Tighten lock nut.

Insert main plunger (4) into drain

with the long side toward the ball

rod opening. Insert ball rod (3) into

the hole in the main plunger. Turn

Lift rod strap

Ball rod

Main plunger

Lock nut

Tools and Supplies