EZ-FLO 10715 Installation guide

EZ-FLO
Brand
EZ-FLO
Model
10715
Type
Installation guide

This manual is also suitable for

EZ-FLO 10715 is a dual control bathroom faucet with pop-up drain. It is engineered to meet the EPA WaterSense flow requirement, so you can conserve water while using it. The faucet is easy to install and comes with all the necessary parts, including an adjustable wrench, pipe tape, Phillips screwdriver, and silicone sealant.

The EZ-FLO 10715 has a variety of features that make it a great choice for your bathroom. The dual controls allow you to easily adjust the water temperature and flow rate. The pop-up drain is convenient and easy to use. The faucet is also durable and made from high-quality materials, so you can be sure that it will last for years to come.

EZ-FLO 10715 is a dual control bathroom faucet with pop-up drain. It is engineered to meet the EPA WaterSense flow requirement, so you can conserve water while using it. The faucet is easy to install and comes with all the necessary parts, including an adjustable wrench, pipe tape, Phillips screwdriver, and silicone sealant.

The EZ-FLO 10715 has a variety of features that make it a great choice for your bathroom. The dual controls allow you to easily adjust the water temperature and flow rate. The pop-up drain is convenient and easy to use. The faucet is also durable and made from high-quality materials, so you can be sure that it will last for years to come.

Dual Control
Bathroom Faucet
Before You Begin
Check to make sure you have the following:
10713
10715
Tools and Supplies
You will need the following to install your new faucet:
Pipe
Tape
Adjustable
Wrench
With Pop-Up
Phillips
Screwdriver
This product is engineered to meet the EPA
WaterSense flow requirement. The flow rate
is governed by the aerator. If replacement is
ever required, be sure to replace it with a
WaterSense compliant lavatory faucet aerator
to retain the water conserving faucets of this
faucet.
Silicone
Sealant
Shut off main water supply before installation.
Faucet Installation
2 Remove assembled
parts from the faucet body.
8 After installing faucet, remove
aerator and turn on water to remove
any left over debris. Reassemble
aerator and tigthen.
3 Place the spout in the
center hole of sink. Secure
parts as shown above.
4 Remove assembled
parts from the faucet
body.
7 Apply pipe tape onto the threads
of the handle valve body inlet port,
connect supply tube and tighten with
lock nut.
5 Place the handle bodies through the
left and right holes. Re-assemble the
parts and tighten mounting nut.
6 Remove protective cap.Connect handle assembly to the spout body with
water supply hose. Push supply hose adapter with hose coupling until you
hear a "click". Pull hose down to make sure connected firmly.
1 Shut off water supply.
5 Insert plunger. Insert ball rod into
drain assembly.
NOTE: Plastic loop on plunger facing
rear of sink is in locked mode and
plunger cannot be removed. Plastic
loop on plunger facing the front of sink
is in unlocked mode and can be
removed for easy cleaning.
6 Insert lift rod through faucet and
attach lift rod strap to lift rod. Push
button to allow lift rod to slide
through. Release to lock.
7 Push down the ball rod so that
the drain is at “open position”.
Rotate the connector on the strap to
the proper height to connect to the
ball rod when it is at “open position”.
2 Remove plunger. Install drain
hole set.
3 Attach rubber washer onto the
thread of drain hole set and
tighten lock nut.
4 Attach drain assembly.
Pop-Up Drain Installation
9
7
6
5
4
3
2
1
Washer
Drain hole set
Lift rod
Main plunger
Lift rod strap
Large rubber washer
Drain assembly
Ball rod
Lock nut
8
Loop toward
front of sink
Drain
Loop toward
rear of sink
Drain
1 Remove old pop-up drain
assembly.
1 Metal Handle Assembly A66E861
2.1 Handle Extension Assembly - Cold A66G378C
2.2 Handle Extension Assembly - Hot A66G378H
3 Retainer Nut A016022
4.1 Ceramic Disc Cartridge - Cold A507104N
4.2 Ceramic Disc Cartridge - Hot A507103N
5 Lock Nut A009387CP
6 Handle Trim Ring A66F620
7 Mounting Hardware Assembly A66D900ZN-H
8 Mounting Hardware A66D455
9 Supply Hose A135141N
10 Aerator 1.2 gpm A553058N
11 Lift Rod A025608
12 50/50 Pop-up Assembly A525371
Keep this manual for ordering replacement parts.
Replacement Parts
Troubleshooting Guide
Minor problems often can be fixed without a plumber. Before doing any work on the faucet, shut off water supply and
close stopper or drain to avoid losing small parts.
noituloSesuaCmelborP
Leak from spout Damaged or dirty seals Disassemble faucet, remove cartridge. Clean or replace
cartridge if necessary. Reassemble.
.
Leak from under handle Damaged cartridge Remove handle. Replace cartridge.
Uneven water spray Clogged aerator Remove aerator. Clean or replace aerator if necessary.
Leak from around aerator Bad aerator seal Remove aerator. Check to see that seal is flat and undamaged.
Replace aerator if necessary.
Water drains slowly or not at all Clogged drain Remove stopper. Remove visible debris.
If still clogged, remove and clean trap. Reassemble.
1.
2.1
2.2
4.1
4.2
8.
3.
6.
5.
7.
11.
12.
9.
10.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

EZ-FLO 10715 Installation guide

EZ-FLO
Brand
EZ-FLO
Model
10715
Type
Installation guide
This manual is also suitable for

EZ-FLO 10715 is a dual control bathroom faucet with pop-up drain. It is engineered to meet the EPA WaterSense flow requirement, so you can conserve water while using it. The faucet is easy to install and comes with all the necessary parts, including an adjustable wrench, pipe tape, Phillips screwdriver, and silicone sealant.

The EZ-FLO 10715 has a variety of features that make it a great choice for your bathroom. The dual controls allow you to easily adjust the water temperature and flow rate. The pop-up drain is convenient and easy to use. The faucet is also durable and made from high-quality materials, so you can be sure that it will last for years to come.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents