Whirlpool WBE3322 A+NFSL AQUA Program Chart

Brand: Whirlpool

Model: WBE3322 A+NFSL AQUA

Category: Fridge-freezers

Type: Program Chart

This manual is also suitable for

A. Control panel

B. Refrigerator Compartment

1. Filter in the fan

2. Lighting

3. Shelves / Shelf area

4. Multi-flow cold air system

5. Cooler compartment (best for meat and fish)

6. Rating plate with commercial name

7. Fruits and vegetables crisper

8. Crisper divider

9. Reversibility kit

10. Door trays

11. Separator

12. Water tank

13. Balcony - eggs tray

C. Freezer Compartment

14. Upper basket (freezing zone)

15. Ice tray and/or cold accumulator

16. Shelves

17. Storage zones for frozen food items (basket or flap)

17a. "Eco green" basket (only in models with ECO

GREEN function)

18. Door seals

19. The freezer door trays for pizza or other frozen

products with a short storage time (2** storage

compartment)

Anti-bacterial protection (depending on the model):

- Antibacterial filter in the fan (1)

- Antibacterial additives in the Crisper (7)

- Door seals are made of material able to inhibit bacterial

growth (18)

Notes:

- Depending on the model the number and type of

accessories may vary.

- In case of power failure the cold accumulator helps to

keep optimal storage temperature longer.

- All shelves and door trays are removable.

- The internal temperatures of the appliance depend on

the ambient temperature, frequency of opening the

doors, as well as location of the appliance. Temperature

setting must consider these factors.

- Unless otherwise specified the appliance accessories

are not suitable for washing dishwasher.

- After inserting food, ensure that the freezer

compartment door closes properly.

TO INCREASE STORAGE

The freezer compartment can be used without the

baskets / flap to increase storage and for large products.

You can place the food products directly on the racks.

HYDROSENSE SHELVES

(depending of the model)

The special contour of the HydroSense shelves creates a

barrier that contain spills and simplifies cleanup,

preventing liquids from leaking onto shelves below.

ORGANIZING MAT (depending on the model)

The Organizing Mat is a mat

designed to better organize the

space on the shelf, and to provide a

soft-touch experience when loading

heavy items on the shelf. Some slots

could also be used to host bottles

(horizontally positioned). In order to remove it (for

cleaning purpose, or to use it on top of another shelf),

first remove the shelf where it is currently placed. The

mat is dishwashable.

NET SHELF (depending on the model)

The Net Shelf is the net which can

be used to store little items

directly under the glass shelf,

taking full advantage of this space.

Pull down the net shelf (using the

lip on the front) to load/unload it.

The net is flexible: do not stress it by loading it with bulky

or heavy items. Maximum weight allowed: 2 kg.

To remove the net (for cleaning purpose, or to use it

under another shelf), you have to first remove the glass

shelf under which the net is currently placed. The net

shelf is dishwashable.

HOW TO START THE APPLIANCE

Fit the spacers (if supplied) on the

upper part of the condenser at

the rear of the appliance.

After plugging the appliance to the

mains, it starts the operation

automatically.

After starting the appliance, wait at least 4-6 hours before

placing food into the appliance. The indicator LEDs on the

control panel light up for approximately 1 second, and

after initialization process, setpoint is displayed.

Note:

- If food is placed in the refrigarator before the appliance

has cooled completely, it may deteriorate.

PRODUCT SHEET

ROBGRUSHSKCZPLIGB FINDKNSGRPENLFD

FAN WITH A BUTTON

The fan improves temperature distribution inside the

refrigerator compartment, allowing better preservation of

stored food.

To switch on the fan press the button (1a). It is advisable

to activate the fan when the ambient air temperature is

over 27 ÷ 28°C or if you perceive drops of water on the

glass shelves or in difficult humidity conditions.

Note:

Do not obstruct the air intake area with food items.

The fan will run ONLY when the compressor is in

operation.

Remember to turn off the fan when there is a lower

ambient air temperature.

If the appliance has the fan it can be equipped with the

antibacterial filter.

Remove it from the box found in the crisper drawer (item

7) and insert into the cover of fan (item 1b).

The replacement procedure is attached with the filter.

CONTROL PANEL DESCRIPTION

1. "Fast Cooling" function

2. Indication of temperature settings

3. Temperature selection / "Fast Cooling" (3sec.minimum)

pushbutton

4. Internal light switch

TEMPERATURE SELECTION

Press the pushbutton on the control panel to adjust the

temperature.

Temperature selection pushbutton is used to set desired

temperature level, from warmest through lower to

coldest .

Pressing pushbutton setpoint will change cyclically.

Temperature set-point is done for both compartments at

one time - fridge and freezer.

At first plug-in of appliance factory set-point is chosen -

medium position.

Following table shows set-points level:

GUIDE TO SELECTING FUNCTIONS

Fast Cooling

The use of this function is recommended when placing a

very high quantity of food in the refrigerator compartment

By pressing and hold the pushbutton on the control panel

for 3 sec. it is possible to increase the cooling speed of the

foods inside the refrigerator compartment.

The Fast Cooling light ( yellow LED) will turn on. The

function is automatically deactivated after 6 hours.

The Fast Cooling function can be manually deactivated by

pressing and hold the same pushbutton on the control

panel for 3 sec., the yellow LED is off.

Note:

- Fast Cooling function should be also switched ON

before placing fresh food to be frozen in the freezer

compartment.

- Fast Cooling function has to be engaged in order to

maximize freezing capacity, thus it has to be engaged

before to add fresh food.

ECO GREEN (depending on the model)

This function gives best food preservation performance

with the smallest energy consumption possible (around 5-

10% less in comparison with the normal settings - middle

temperature ) if there is lower amount of food to be

preserved in the appliance.

When ECO GREEN function is activated only these ECO

compartments should be used in order to have the

perfect food preservation:

- 2 "eco green" shelves in the fridge (with green frames)

- 1 "eco green" basket in freezer compartment

High temperature

Mid-high temperature

(Eco Green)

Middle temperature

Mid-low temperature

Low temperature

12 3

ROBGRUSHSKCZPLIGB FINDKNSGRPENLFD

Legend

Led ON

Fast Cooling

OFF

PRODUCT SHEET

To active the Eco Green function press the pushbutton

on the control panel to choose the mid–high

temperature, as showed here below:

ABNORMAL APPLIANCE OPERATION

When the product is plugged in to the mains, during first

10 minutes of its performance, possible temperature

sensor failure will be displayed according to following

table:

The appliance will work preserving the food stored, but it

is necessary to contact after-sales service and provide

alarm code.

DEFROSTING THE FREEZER

COMPARTMENT

No Frost freezers provide chilled air circulation around the

storage areas and prevent the formation of ice, thereby

completely eliminating the need for defrosting. Frozen items

don't stick to the walls, labeling stays legible and storage

space remains neat and clear.

DEFROSTING THE REFRIGERATOR

COMPARTMENT

Refrigerator compartment defrosting is completely

automatic.

Droplets of water on the rear wall inside the refrigerator

compartment indicate that the automatic defrost phase is

in progress. The defrost water is automatically run into a

drain hole and collected in a container, where it

evaporates.

REPLACING THE LIGHT

(depending on the model)

BULB's LIGHTING

Always disconnect the refrigerator from the power supply

before replacing any light bulb.

If the inside light is not working, it is necessary to:

1. Remove the light cover: put

the fingers into the side

ventilation holes (1), stretch

the cover gently and move it

upwards.

2. Check the bulb. If necessary unscrew the broken bulb

and replace it with the new one (max power of the

light bulb is given on the light cover).

3. Put on the light cover.

Do not leave the bulb

uncovered.

LED's LIGHTING

If the inside LED light is not

working, it must be replace by

service.

ROBGRUSHSKCZPLIGB FINDKNSGRPENLFD

PRODUCT SHEET

UTILISATION AND MAINTENANCE OF THE WATER DISPENSER AND FILTER (if present)

Water dispenser

First use

The first time you use the water dispenser or after a long period left not used wash the tank and the filter with water.

The water dispenser provides fresh, filtered water, without the need of opening the refrigerator door. This will reduce

the number of times the door is opened, thus also reducing energy consumption of the product.

Fitting and replacing the active carbon filter

The water filter should be removed from the foil bag (found in the crisper drawer (item 7). Follow the instructions

provided with the filter.

Important: If the filter is left dry for an extended period of time, its performance may be reduced. Immerse the filter in

water for a few seconds to reinstate optimum performance.

Eco Green

Legend

Led ON

Refrigerator Evaporator

sensor failure

Refrigerator sensor failure

Refrigerator & Evaporator

sensor failure

Legend

Led OFF

Led Flashing

Water tank (fig. 1)

The water tank is made of antibacterial material. This prevents and reduces the proliferation of

bacteria.

An internal container, with an active carbon filtered ensures water filtration.

To fill the tank: rotate the water inlet towards you and fill with water, using a jug or other suitable

container. Once the tank is full, close the water inlet by moving it back to its original position.

Always use drinking water only: any other liquid may impair product performance.

Obtaining filtered water (fig. 2)

After filling the tank, the water may not be immediately available. This is because the filtering

process may require a few minutes (depending on the amount of water in the tank).

To dispense water: with the refrigerator door closed, press the water dispenser tab with the glass.

If for safety reason water delivery must be prevented, simply press the stop at the back of the tab.

To release water delivery move the stop back to its original position.It is recommended to drink

the supplied water from the dispenser in 6 hours.

Cleaning the water tank (fig. 3-4-5-6-7-8-9)

Periodically clean the water tank with running water. Twice a year it is recommended to keep

healthy the unit using specific products based on diluted chlorine that not modify the material

properties and rinse with current water.

To clean the tank, proceed as follows:

- (fig. 3) release and remove the top door tray

- (fig. 4) release and remove the water tank by lifting it and pulling towards you. Place the tank on a

flat surface, remove and wash the top cover.

Note: the tank must be refitted in its position as soon as possible, to prevent the

refrigerator from overheating.

- (fig. 5a -5b) remove the internal container and the filter, and wash them separately.

When washing the filter, only use clean water (no detergent or sharp tools). To

clean the disk filter, first remove it from the container.

- (fig. 6) for a more thorough cleaning, remove the valve cap (the fitting connecting the

tank to the refrigerator) by rotating it anticlockwise. Clean the cap. Important: do not

pull on the valve body (fig. 7).

- (fig. 8) replace the valve cap by rotating clockwise.

- (fig. 9) fit the tank back in place by placing it between the lateral guides of the door and

pushing it in position, ensuring that the valve is back in its original seat. Check that the

there are no gaps between the rubber seal of the tank and the door.

Suggested exchange of filter for a standard consumption usage of:

3,0 l/day 4 months

4,5 l/day 3 months

6,0 l/day 2 months

Filter replacement is not covered by product warranty. To order more water filter cartridges, please

contact your after-sales service.

5019 637 01093

Printed in Poland 01/11

ROBGRUSHSKCZPLIGB FINDKNSGRPENLFD

PRODUCT SHEET

Stop

Activation

device

Water

drip

tray

Fig. 2

Fig. 1

Ta nk

To fill the tank, rotate the cap

in the direction of the arrow

Fig. 3

Fig. 4

Fig. 5

Fig. 6

Fig. 7

Fig. 8

Fig. 9

Whirlpool WBE3322 A+NFSL AQUA Program Chart

Brand: Whirlpool

Model: WBE3322 A+NFSL AQUA

Category: Fridge-freezers

Type: Program Chart

This manual is also suitable for

Download PDF

report

Whirlpool WBE3322 A+NFSL AQUA Program Chart

This manual is also suitable for

Whirlpool WBE3322 A+NFSL AQUA Program Chart

Related papers

Other documents