Hotpoint TFUL 183 XV WD H Program Chart

Brand: Hotpoint

Model: TFUL 183 XV WD H

Type: Program Chart

1. External indicators of Power On and alarms

2. Control panel

3. Main LED’s lighting

4. Fan

5. Lighting in Multi-flow*

6. Shelf divider*

7. Multi-flow cold air area*

8. Bottle rack *

9. Sensor cover

10. Zero degrees drawer*

11. Rating plate with commercial name

12. Cooler compartment (best for meat and fish)

13. Area shelves

14. Fruits and vegetables crisper

15. Crisper divider *

16. Door reversibility kit

17. Egg tray*

18. Water tank

19. Bottle holder*

20. Door trays

21. Door seal

* Available on selected models

HOW TO START THE APPLIANCE

After plugging the appliance to the mains, it starts the

operation automatically. After starting the appliance, wait

at least 4-6 hours before placing food into the appliance.

When the appliance is connected to the power supply,

the display lights up and all the icons appear on the

display for approximately 1 second. The default (factory)

values of the freezer compartment settings light-up.

HOW TO REVERSE THE DOOR SWING

- see enclosed Instructions for Use

Is recommended to reverse door swing by two persons.

Specifications, technical data and images may vary

from model to model

Read the Instructions for Use carefully before

using the appliance.

400010819910

QUICK START GUIDE

ALARMS TABLE

ALARM TYPE Signal Cause Cure

Door open alarm

The acoustical alarm is activated and the Alarm Indicator

blinks.

The door has remained open for more than 2 minutes Close the door or press the Stop Alarm to mute the acoustical alarm.

Malfunction The letter “F” blinks on the display (°C) Product malfunction. Contact the After-sales Service

POWER ON (EXTERNAL LED) indicator

An external green LED showing that the appliance is switched ON.

It automatically turns off when opening the door.

ALARM (EXTERNAL LED) indicator

This red LED can blink to show the occurrence of an alarm or a failure even when the

door is closed. Please open the door and check on the internal Control Panel which

alarm/failure is occurring.

TEMPERATURE

DISPLAY

ON/STANDBY button

To put the product in Stand-by, press

and hold the button for 3 seconds.

All the icons turn off except On/

Standby indicator . To reactivate

the appliance press once (briefly) this

button. (see the Instructions for Use).

TEMPERATURE button

Press the Temperature button to change

the temperature: the value changes cyclically

between 8°C ad 2°C.

Note: Displayed set points correspond to the

average temperature throughout the whole

refrigerator.

SUPER COOL button

Using Super Cool function it is possible to increase the cooling capacity in the refrigerator

compartment. The use of this function is recommended when placing a very high quantity of food

in the refrigerator compartment. Press the Super Cool button

to activate Super Cool function.

When activated, the Super Cool indicator turns on. The function is automatically disabled after

6 hours, or can be manually disabled by pressing Super Cool button again.

STOP ALARM button

Press in case of alarm to mute the acoustic alarm.

HOLIDAY button

This function can be activated to reduce the energy

consumption of the appliance during a prolonged

period of time. Before activating the feature, all

perishable food should be removed from the

refrigeration compartment and make sure that

the door is closed properly, since the refrigerator

will maintain a suitable temperature to prevent

the formation of unpleasant odors (+12°C). To

activate/ deactivate press the Holiday mode button

for 3 seconds. When the function is enabled, the

related symbol will light up and the temperature of

the refrigerator compartment will be set to a higher

setpoint (the temperature display will show the

new temperature setpoint of +12°C). Changing the

temperature setpoint will automatically deactivate the

function.

FAN

The Fan improves temperature distribution inside the

product, allowing better preservation of stored food.

By default, the fan is switched on. To switch off the

FAN press and hold Holiday

and Stop Alarm

buttons at the same time for 3 seconds until an

audible signal sounds and fan icon will turn off

as confirmation that the fan has been switched off.

To switched on the FAN repeat the same procedure.

As a confirmation audible signal sounds and the icon

turns on.

SUPER COOL indicator

ALARM indicator (see the below Alarms Table)

ON/STANDBY indicator

VACATION indicator

QUICK START GUIDE

400010819910

UTILISATION AND MAINTENANCE OF THE WATER DISPENSER AND FILTER

Water dispenser

First use

The first time you use the water dispenser or after a long period left not used wash the tank and the filter with water.

The water dispenser provides fresh, filtered water, without the need of opening the refrigerator door. This will reduce the number

of times the door is opened, thus also reducing energy consumption of the product.

Fitting and replacing the active carbon filter

The water filter should be removed from the foil bag (found in the crisper drawer (item 5). Follow the instructions provided with

the filter.

Important: If the filter is left dry for an extended period of time, its performance may be reduced. Immerse the filter in water for a

few seconds to reinstate optimum performance.

To ﬁ ll the tank, rotate the cap in the

direction of the arrow

Tank

Fig.1

Water tank (fig. 1) The water tank is made of antibacterial material. This

prevents and reduces the proliferation of bacteria. An internal container,

with an active carbon filtered ensures water filtration. To fill the tank: rotate

the water inlet towards you and fill with water, using a jug or other suitable

container. Once the tank is full, close the water inlet by moving it back to its

original position. Always use drinking water only: any other liquid may

impair product performance.

Stop

Activation

device

Water

drip

tray

Fig.2

Obtaining filtered water (fig. 2)

After filling the tank, the water may not be immediately available. This is

because the filtering process may require a few minutes (depending on the

amount of water in the tank).

To dispense water: with the refrigerator door closed, press the water dispenser

tab with the glass. If for safety reason water delivery must be prevented,

simply press the stop at the back of the tab. To release water delivery, move

the stop back to its original position. It is recommended to drink the supplied

water from the dispenser in 6 hours.

Fig.3

Cleaning the water tank (fig. 3-4-5-6-7-8)

Periodically clean the water tank with running water. Twice a year it is

recommended to keep healthy the unit using specific products based on

diluted chlorine that not modify the material properties and rinse with current

water.

To clean the tank, proceed as follows:

- (fig. 3) release and remove the water tank by lifting it and pulling towards you.

Place the tank on a flat surface, remove and wash the top cover.

Note: the tank must be refitted in its position as soon as possible, to

prevent the refrigerator from overheating.

Fig.4

- (fig. 4) remove the internal container and the filter, and wash them separately.

When washing the filter, only use clean water (no detergent or sharp

tools). To clean the disk filter, first remove it from the container.

Fig.5 Fig.6

- (fig. 5) for a more thorough cleaning, remove the valve cap (the fitting

connecting the tank to the refrigerator) by rotating it anticlockwise. Clean the

cap. Important: do not pull on the valve body (fig. 6).

Fig.7

- (fig. 7) replace the valve cap by rotating clockwise.

Fig.8

- (fig. 8) fit the tank back in place by placing it between the lateral guides of the

door and pushing it in position, ensuring that the valve is back in its original

seat. Check that the there are no gaps between the rubber seal of the tank and

the door.

Water Filter Duration

To ensure optimum performance you should change the water filter according with the following table:

Water consumption (average) Filter duration

3,0 l/day 4 months

4,5 l/day 3 months

6,0 l/day 2 months

Filter replacement is not covered by product warranty. To order more water filter cartridges, please contact your after-sales

service.

Hotpoint TFUL 183 XV WD H Program Chart

Hotpoint TFUL 183 XV WD H Program Chart

Hotpoint TFUL 183 XV WD H Program Chart

Related papers

Other documents