BARRON PXP Tritium Thermoplastic Series Installation guide

Brand
BARRON
Model
PXP Tritium Thermoplastic Series
Type
Installation guide
IMPORTANT SAFEGUARDS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
Basic safety precautions should always be followed including the following:
• Installation and servicing of this equipment should be performed by qualified service personnel only.
• Do not mount near gas or electrical heaters.
• Do not use outdoors.
• Equipment should be mounted in locations and at heights where it will not be readily subjected to tampering
by unauthorized personnel.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
• Any modification or use of non-original components will void the warranty and product liability.
• Do not use this equipment for other than intended use.
SAVE THESE INSTRUCTIONS!
Technical Support ■ (623) 580-8943 ■ [email protected]
10070261 REV 1 - 05/22 1800-533-3948 www.barronltg.com
PXP Series
Installation Instructions
Fixture Preparation
1. Remove the frame and window by pressing the
frame release button and set both aside.
(Fig. 1)
Wall Mount (Single Face Only)
1. Secure the fixture to the mounting surface using
the (2) 1-1/2” screws in the best two holes for
the application. There are eight holes available
for mounting the fixture. (Fig. 2)
2. Replace the legend, followed by the window.
3. Snap the frame back into place on the fixture.
Ceiling or End Mount
1. Secure the mounting bracket to the mounting
surface using the (2) 1-1/2” screws provided.
2. For double-face signs, go to Double-Face
Fixture Mounting section.
3. Secure the fixture to the mounting bracket in
the top two holes or either of the side two holes
for ceiling or end mounting, respectively, using
the (2) 5/8” screws provided. (Fig. 3)
4. Replace the legend, followed by the window.
5. Snap the frame back into place on the fixture.
Fig. 1
Frame Release Button
Legend
Window
Frame
Fig. 2
1½” x 2
END MOUNT
CEILING MOUNT
5/8” x 2
Fig. 3
10070261 REV 1 - 05/22 2 800-533-3948 www.barronltg.com
PXP Series
Installation Instructions
Double-Face Fixture Mounting
1. Complete step 1 of the Ceiling or End Mount section
if not done already.
2. Align the top or side holes of the (2) EXIT fixtures with
the mounting bracket, and align the spacer with the
opposite two holes, as shown. (Fig. 4)
3. Secure the fixtures using the (4) sets of screws and
nuts provided.
4. Replace the legend, followed by the window.
5. Snap the frame back into place on the fixture.
Canopy Mount
1. Secure the standard pendant mount to the ceiling.
2. Secure the mounting bracket to the pendant using the
provided nut, as shown. (Fig. 5)
3. Follow steps 3-5 of the Ceiling or End Mount
section.
Fig. 4
SPACER
INSERT BOLTS
Fig. 5
PENDANT
10070261 REV 1 - 05/22 3 800-533-3948 www.barronltg.com
PXP Series
Installation Instructions
  • Page 1 1
  • Page 2 2
  • Page 3 3

BARRON PXP Tritium Thermoplastic Series Installation guide

Brand
BARRON
Model
PXP Tritium Thermoplastic Series
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents