BLOTZ B10-WF-002, B10_WF_002 Assembly Instructions

Hello! I've reviewed instructions for the BLOTZ Snake Rail Fence B10-WF-002 model. This document outlines the assembly process, including using glue, cleaning joints, and alternating posts. I'm here to answer any questions you have about building your model.
What type of glue is required?

What tool is needed to remove parts from sprue?

What can be used to clean the joints?

10mm Snake Rail Fence

B10-WF-002

Please read these instructions fully before starting construction.

PVA or equivalent glue will be required to stick sections together.

Sand paper can be used to gently clean any joints.

A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember

to cut away from yourself at all times.

During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while

you allow glue to dry.

Each section of fence is formed from the pieces shown above.

Note, the three pieces on the left should alternate with 1: the post flush to the base of the fence, 2: The post

extends beyond the base of the fence, 3: The post is flush to the base of the fence

First insert the section which has 2 uprights on it.

Slide the rails of the next piece between the rails of the first piece (see pic) and slot the tab into the base.

Repeat this with the other two pieces to get the completed fence.