Form No. 778-11997© 2010 13AC762
Attach the red cable to the positive (+) battery
terminal and attach the black cable to the
negative (–) battery terminal with the bolts and
hex nuts.
Position the red rubber boot over the
positive battery terminal.
With the wheels of the tractor 1.
pointing straight forward,
place the steering wheel
over the steering shaft.
Secure the steering 2.
wheel with the washer
(cupped side down)
and hex bolt.
Push the steering 3.
wheel cap downward
until it “clicks” into
place.
Attach the dash collar
with the two screws
found in either side
of the dash console.
Remove the hex screw from the base 1.
of the seat.
Position the seat over 2.
the seat pan, with
the two forward seat
mount tabs fitting into
the provided grooves.
Slide the seat rearward 3.
and align the center
mounting hole in
the seat with the slot
in the seat pan and
secure the seat with
the hex screw.
Hex Screw
Remove the shipping brace from the
discharge opening by grasping it
between your thumb and index finger
and rotating it clockwise.
PTO (Blade
Engage) Lever
Shift
Lever
Throttle
Control
Ignition
Switch
Brake
Pedal
Tools Required:
• ⁄-inch wrench (or adjustable wrench)
• ⁄-inch wrench (or adjustable wrench)
• /-inch socket wrench
1
4
3
2
5
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .
Need Help? Call 1-888-TO-HELP-U