Angelo Decor AD93696 Operating instructions

Type
Operating instructions
Thank you for buying an Angelo Decor Fountain!
We hope you will find these instructions helpful in setting up your fountain.
If you have any issues with this item, please DO NOT return the unit to place of purchase.
Please visit our web site, www.angelodecor.com, for assistance and warranty information.
First unpack carton carefully, arranging parts safely in your working area.
The final assembly should
look like this
Now simply fill with clean water and plug into a grounded GFCI outlet
We recommend keeping bowl 3/4 full of water to avoid pump burnout.
The pump comes pre installed with this fountain. Carefully position it
so that the pump sits flat and level on the base. The cord needs to
have enough slack to sit flat and level on the base and may need to be
adjusted.
Once you have positioned the
pump, ensure the cord seal is
tight and secure.
Carefully align the small pipe at the
base of the middle section with the pre
-
installed pipe in the bowl and carefully
slide in place.
Pass the tubing from the top section down
through the opening. Slide the top piece into
place by aligning the two pipes as shown.
Install the pump
access door. Install the legs as
shown above.
Connect the pump to
the tubing from the top
through the pump
access opening. Be
sure the pump is sitting
flat and the tubing is
not kinked.
  • Page 1 1

Angelo Decor AD93696 Operating instructions

Type
Operating instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI