Brodit 654977 Datasheet

Category
Holders
Type
Datasheet
27 January, 2015, www.brodit.com, © 2015 Brodit AB
Product 654977
654977 ProClip
Center mount
The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for
your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is
car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required
and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
EAN: 7320286549776
Item no 654977 fits:
Holden Insignia 14-15 (Australia)
Vauxhall Insignia 14-15 (England)
1(2)
1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before installing the ProClip.
1. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Remove the adhesive tape
covers on the ProClip. Press the angled left edge of the ProClip into the gap on the inside of the frame
surrounding the air vent.
2. Press the angled right edge of the ProClip into the gap on the inside of the frame surrounding the air vent. Pay
attention so the ProClip goes above the hook/clip keeping the frame in place (see arrow).
3. Press firmly on the ProClip so the edges goes all the way into the gaps and the tape attaches properly.
4. The ProClip is in place.
2(2)
  • Page 1 1
  • Page 2 2

Brodit 654977 Datasheet

Category
Holders
Type
Datasheet

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI