Brodit 654901 Datasheet

Category
Holders
Type
Datasheet
27 January, 2015, www.brodit.com, © 2015 Brodit AB
Product 654901
654901 ProClip
Center mount
The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for
your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is
car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required
and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
EAN: 7320286549011
Item no 654901 fits:
Seat Toledo 13-15 (England)
Skoda Rapid 13-15 (England)
1(2)
1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read the instructions and look at the pictures before attaching the ProClip. This ProClip can be placed on
desired place on the width of the air vents.
1. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Peel off the adhesive tape
cover on the ProClip. Press the thin end of the enclosed gap opener into the gap surrounding the center console
control panel, to widen the gap.
2. Press the lower angled edge of the ProClip into the gap next to the gap opener.
3. Press the top part of the ProClip forward and at the same time flex it downward so the top part of the ProClip
can go in at the top edge of the air vent. Release pressure of the ProClip so it flexes back and the adhesive tape
attaches. Remove the gap opener.
4. The ProClip is in place.
2(2)
  • Page 1 1
  • Page 2 2

Brodit 654901 Datasheet

Category
Holders
Type
Datasheet

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI