Mircom LT-6912-TX3-TOUCH-WR-BB Installation guide

LT-6912 Rev 0 Page 1 of 2

TX3-TOUCH-WR-BB Installation Instructions

The TX3-TOUCH-WR-BB backbox is required when the cables are brought to the unit in a conduit (not from the

wall).

1. Mount TX3-TOUCH-WR-BB on the wall using fasteners in the 4 mounting holes shown below.

2. Mount TX3-TOUCH-S15B-WR or TX3-TOUCH-S15S-WR on the 4 posts shown below, and secure with

the 4 nuts that are included with TX3-TOUCH-WR-BB.

3. To prevent water entering the Touch Screen unit, use an elbow connector to run the wires from one of the

knockouts on the back of TX3-TOUCH-S15B-WR or TX3-TOUCH-S15S-WR to the knockout on the

bottom of TX3-TOUCH-WR-BB.

Figure 1. TX3-TOUCH-WR-BB mounting holes and posts

Mounting holes

Mounting posts for TX3-TOUCH-S15B-WR

or TX3-TOUCH-S15S-WR

Mounting posts for TX3-TOUCH-S15B-WR

or TX3-TOUCH-S15S-WR

Knockout on

bottom for wiring

LT-6912 Rev 0 Page 2 of 2

Figure 2. Installing TX3-TOUCH-WR-BB

Figure 3. TX3-TOUCH-WR-BB dimensions (inches)

Mircom

http://www.mircom.com

Toll Free: 1-888-660-4655

Local: 905-660-4655

Fax: 905-660-4113

TX3-TOUCH-S15B-WR or

TX3-TOUCH-S15S-WR

(door not shown)

TX3-TOUCH-WR-BB

4 nuts

0.500

1.500

24.192

1.656

70°

16.300