1. Introduction
DEDICATED MICROS TYPE 285 CEILING / WALL MOUNT HOUSING
This range of ceiling / wall mount housings have been designed to provide elegant but cost
effective protection for indoor surveillance cameras. The housing is all steel construction with
replaceable glass window (polycarbonate to special order) powder coated and stoved. The cover is
hinged at the rear with a vandal proof 1/4 turn lock at the front. The base to ceiling fixings are only
accessible when the cover is open, which adds up to a high degree of vandal protection. 20mm
Dia. cable entry holes are provided at the rear and in the base. The camera platform offers a limited
degree of pan & tilt movement which enable the installer to adjust the camera viewing direction
after the housing has been fitted. A Ceiling Tile Option is available comprising the standard housing
mounted to a 3mm thick 600mm (2 foot) square alum alloy ceiling tile via a cable feed through
pivot, with a locking screw.This arrangement enables the housing to be rotated to point in any
desired direction. By the addition of a right angled bracket the housing can be converted to the Wall
Mount Option allowing the camera to be mounted at any position on a wall.
Maximum size camera/lens: that can be fitted into the Type 285 is:-
70 WIDTH X 60 HEIGHT X 200 LENGTH
SPECIFICATION
MATERIAL: 1.5mm steel
ENVIRONMENTAL PROTECTION: BS EN 60529 IP40
CONNECTION: 20 mm Dia.Entry hole in the rear & base
FINISH: Powder coated and stoved
Type 285 Installation Manual Page. 1