Auralex Snap-On Anchor User guide

Type
User guide
Installation & User Guide
Auralex® Acoustics, Inc.
1-800-959-3343 | 317-842-2600 | Auralex.com
9955 Westpoint Drive, Suite 101, Indianapolis IN USA 46256
Snap-On Anchor
1164-609.Snap-On Anchor User Guide (01/13/2020 - 9:08 AM)
Mark each
installation point on
the back of the panel
using a marker 6” in
from each side.
Screw the Snap-On
Anchors into the back
of the panel using the
Snap-On Hex Driver
tool. Making a small
slit with a utility knife
can aid in starting the
anchors insertion.
➊ ➋
Insert marking plugs
into the Snap-On
anchors.
Push panel against
wall to mark anchor
locations.
Firmly push the panel
onto the installed
ratchet plugs to
complete your
installation.
Snap-On
Anchor
Snap-On
Marking Plug
Ratchet
Plug
Snap-On Hex
Driver
Screw ratchet plugs
into wall anchors
appropriate for your
wall construction and
weight of your panel. 2’
x 2’ panels = 8 lb.
2’ x 4’ panel = 16 lb.
4’ x 4’ panel = 32 lb.
NOTE: Ratchet plugs
are directional.
NOTE: Snap-On Anchors should only be used with 2” ProPanels. Use four anchors
per panel, do not use with panels greater than 16 sq/ft in area.
  • Page 1 1

Auralex Snap-On Anchor User guide

Type
User guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI