Auralex Carl Tatz Signature Series™ Kits User guide

Brand
Auralex
Model
Carl Tatz Signature Series™ Kits
Type
User guide
Installation & User Guide
Auralex® Acoustics, Inc.
1-800-959-3343 | 317-842-2600 | Auralex.com
9955 Westpoint Drive, Suite 101, Indianapolis IN USA 46256
CTDTCT™ Corner Trap
1525-317.CTDTCT UG (01/13/2020 - 11:29 AM)
CTDTCT Panel - Front face. Installation of this panel assumes that
all the corner mounted panels in a trihedral corner are in place prior
to installing the CTDTCT panel with the exception of one of the
abutting horizontal corner panels.
Using a SO Hex Driver install two SNAP-ON Anchors into the rear
surface of the panel, parallel to the bottom edge of the panel and
inboard of the edge of the fabric covering. Install a single Cloud
Anchor near the top tip of the panel just inside the fabric border.
Rear of CTDTCT Panel with
all three anchors installed.
Cloud Anchor
Bottom
SO Hex Driver & Snap-On Anchor
Cloud Anchor Snap-On AnchorsSO Hex Driver
Bottom Edge
of Panel
Snap-On Anchor
Ratchet Plug
10-24 Machine Screw
#10 Flat Washer
10-24 Nut
Mending Plate
Snap-On Anchor Ratchet Plug and hardware
(shown in order of assy)
Mending Plate / Ratchet Plug assembly ready for installation
into the Snap-On Anchor. Note the orientation of the Ratchet
Plug flutes relative to the screw head.
Auralex® Acoustics, Inc.
1-800-959-3343 | 317-842-2600 | Auralex.com
9955 Westpoint Drive, Suite 101, Indianapolis IN USA 46256
Installation & User Guide
Push Ratchet Plug / Mending Plate assembly into the two
Snap-On Anchors at the bottom edge of the panel. Orient
the mending plate so that it is pointing down and overhangs
the bottom edge of the panel
• Mount the appropriate screw anchor in the ceiling a few
inches inboard from where the tip of the CTDTCT Panel
touches the ceiling (user supplied).
• Insert the proper size screw eye into the ceiling anchor
installed in the ceiling (user supplied).
• Install CTDTCT into the corner by resting the bottom edge
of the panel on the top edge of the top vertical corner
panel. The mending plates extending past the bottom of
edge of the CTDTCT Panel will index these two panels
relative to each other.
• Zip tie the ring of the Cloud Anchor at the upper tip of the
CTDTCT Panel to the screw eye mounted in the ceiling end
gently snug.
• Install the remaining horizontal corner panel that abuts
the open side of the CTDTCT Panel to complete the
installation.
Ceiling Anchor
  • Page 1 1
  • Page 2 2

Auralex Carl Tatz Signature Series™ Kits User guide

Brand
Auralex
Model
Carl Tatz Signature Series™ Kits
Type
User guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents