AEG GYB06116XA Installation guide

1. Remove the plastic plug and mount

the adapters. Don’t forget the

sealings!

2. Mount the brass adaptor into the

safety group and place the expansion

vessel;

3. Attach the assembly at the bracket

using the tie wrap;

4. Determine the position of the

bracket in the kitchen cabinet, use

the enclosed screws to secure the

assembly to the cabinet wall or back.

• It is recommended that pipes

are cleaned before installation

(clean the boiler also if the

safety unit is replaced)

• The expansion groups must be

installed by connecting the

discharge tundish to the

drainage piping.

Safety group

Use sealant!

3 4

Add tie wrap!

Before

Installation

Flow

direction!

For the expansion groups to work

properly, it is required to operate the

expansion relief valve ❶ by hand at

least every 6 months.

UseInstallation

❶