Page is loading ...
Electric current! Danger to life!
Only skilled or instructed persons may
carry out the following operations.
Lebensgefahr durch elektrischen Strom!
Nur Elektrofachkräfte und elektrotechnisch
unterwiesene Personen dürfen die im Folgenden
beschriebenen Arbeiten ausführen.
Tension électrique dangereuse !
Seules les personnes qualifiées et averties doivent
exécuter les travaux ci-après.
¡Corriente eléctrica! ¡Peligro de muerte!
El trabajo a continuación descrito debe ser realizado
por personas cualificadas y advertidas.
Tensione elettrica: Pericolo di morte!
Solo persone abilitate e qualificate possono eseguire
le operazioni di seguito riportate.
触触电电危危险险！！
只允许专业人员和受过专业训练的人员进行
下列工作。
Электрический ток! Опасно для жизни!
Только специалисты или проинструктированные
лица могут выполнять следующие операции.
تتﻮﻮــــﻣﻣﺮﺮــــﻄﻄﺧﺧ!!ﻲﻲﺋﺋﺎﺎــــﺑﺑﺮﺮﻬﻬﻛﻛررﺎﺎــــﻴﻴﺗﺗ!!ﺮﺮﻳﻳﺬﺬــــﺤﺤﺗﺗ!!
ﺐـــــﻴﻛﺮﺘﻟا و ﺔﻧﺎﻴـــــﺼﻟا لﺎـــــﻤﻋا ﻢـــــﺘﺗ ﻻ
ﻦﻴﺑرﺪــــﻤﻟا ﻦﻴﻠﻣﺎــــﻌﻟا ﻞــــﺒﻗ ﻦــــﻣ ﻻا !
en
de
fr
es
it
zh
ru
ar
03/22 IL05305008Z (P51993)
Instruction Leaflet
Montageanweisung
Notice d’installation
Instrucciones de montaje
Istruzioni per il montaggio
安
安装装说说明明
Инструкция по монтажу
تتﺎﺎــــــــــﻤﻤﻴﻴﻠﻠﻌﻌﺘﺘﻟﻟااررﻮﻮــــــــــﺸﺸﻨﻨﻣﻣ
1/2
Instruction Leaflet IL05305008Z (P51993) Effective March 2022
Supersedes May 2018 E76 Series
IntelliView Contrast Measurement
Optical Sensors
E76…
Dimensions
aSET Button
bOutput LED
cReady/Error LED
81.5 mm (3.21")
43 mm (1.69")
15 mm
(0.59") 25 mm
(0.98")
34 mm
(1.34")
2.5 mm
(0.10")
10 mm
(0.39")
M12
1.5 mm
(0.06")
2 mm
(0.08")
4 mm
(0.16")
4 mm
(0.16")
3.5 mm
(0.14")
24 mm
(0.94")
3.8 mm
(0.15")
14 mm
(0.55")
M18 x 1
No. 2 ⌀3.8 mm
No. 2 (⌀0.15")
① ②
③
03/22 IL05305008Z (P51993)
USA:
Eaton.com/eatoncare
+1 877-386-2273
Eaton.com/sensors
+1 800-426-9184
Eaton.com/contacts
Eaton.com/aftersales
Eaton.com/documentation
USA: Eaton Corporation, W126 N7250 Flint Drive, Menomonee Falls, WI 53051, USA Publication No.
IL05305008Z (P51993) March 2022
EU: Eaton Industries GmbH, Hein-Moeller-Straße 7-11, 53115 Bonn, Germany
UK: Eaton Electric Ltd., P.O. Box 554, Abbey Park, Southampton Road, Titchfield, PO14 4QA, UK
Eaton.com/recycling
2/2 © 2012 Eaton Corporation
Eaton is a registered trademark of Eaton Corporation. All other trademarks are property of their respective owners.
Wiring diagrams
Controls and adjustment
Initial Setup
The E76 Series Optical Contrast Sensors use a patented technology to accurately detect a grayscale mark on a contrasting background material.
Two setup modes are available:
–Simple Setup
For most applications.
–Fine Detection Setup
Used when the contrast between the target mark and the background is insufficient to result in a detection using the Simple Setup method.
Simple Setup Instructions
– The mark to be detected should be placed correctly at the right reading distance within the sensor spot.
– Press and hold the SET button until the Ready/Error LED turns off.
– Release the SET button and wait for the Ready/Error LED to turn green.
– The sensor is now ready to detect the pre-set colored mark or object.
Fine Detection Setup Instructions
– The mark to be detected should be placed correctly at the right reading distance within the sensor spot.
– Press the SET button, do not hold it.
– The Ready/Error LED should turn off.
– Push and hold the SET button until the Ready/Error LED blinks green.
– Place the background under the sensor spot.
– Press the SET button again until the Ready/Error LED turns off.
– The sensor is now ready to detect with high precision the pre-set colored mark.
NPN PNP
→ EN 60947-5-2
Yellow LED Indicates when target is present.
Green/Red LED
(Ready/Error)
When continuously green, indicates sensor is operating in normal condition and functioning correctly.
When blinking red/green, indicates an incorrect sensor setting (→ Initial Setup).
SET Button Activates the self-setup procedure
￫If a setting error occurs, simply reset the process by pressing and holding the SET button.
24
1
3
0 V
+V
0 V
+V
LT. OP.DK. OP. Load Load
24
1
3
0 V 0 V
+V +V
Load Load LT. OP.DK. OP.
/