
MIMO88
How to reset to factory defaults:
This is the procedure to force a “reset to factory defaults” and take the unit back to the
previous firmware version, (please remember: all user data will be lost, and the unit
will have the factory defaults!!)
fig.1
STEPS:
- power OFF
- put jumper on FACTORY position (see fig.1) in the indicated pin
- power ON
- wait until the led in faceplate blinks quickly
- power OFF
- remove the jumper
- power ON again
- After that, if you connect, upgrade the unit with the last firmware from our website:
www.ecler.com