Newport Brass 1030-5503/01 Installation guide

Brand: Newport Brass

Model: 1030-5503/01

Category: Sanitary ware

Type: Installation guide

INSTALLATION INSTRUCTIONS

W

ALL MOUNT POT FILLER

Model No’s:

9481, 9482, 9485, 2470-5503, 1200-5503

1030-5503, 2500-5503, 2940-5503,

3170-5503, 3200-5503, 3210-5503,

3160-5503, 3180-5503, 3190-5503,

3220-5503,3290-5503

Congratulations on the purchase

of your Newport Brass product,

an excellent choice, that will give you

years of quality service and enhance

the look and style of your home.

9481

Figure 2

1

2

1/2”

MAX

Recommended Installation by a Professional Plumbing Contractor

Note:

I. Framing support is required for mounting flange to ensure sufficient strength of installation.

II. While drilling, extreme care should be taken to avoid damage to hidden electrical or plumbing lines.

III. Pot filler may get hot when arm is positioned above the stove’s burner. Swing the pot filler arm away

from the stove after use.

IV. The use of petroleum based plumbers putty on this product will nullify the warranty. We recommend

the use of silicone based sealing materials as needed.

Installation:

1. Shut off water supply. Tap into existing cold water supply and run to desired location on the wall. 1/2 NPT

connection (not supplied) is required and should protrude 1/2” out from finished wall. Apply thread

sealant to protruding end of 1/2 NPT. See Figure 1.

2. Center and secure the mounting FLANGE (1) over 1/2 NPT water supply with SCREWS (2) provided.

See Figure 2.

3. Temporarily thread ESCUTCHEON with O-RING (3) onto mounting FLANGE (1). See Figure 3.

4. Thread SPOUT ASSEMBLY (4) through ESCUTCHEON/O-RING (3) and onto 1/2 NPT water supply.

See Figure 4.

5. Remove ESCUTCHEON/O-RING (3) to expose mounting FLANGE (1). See Figure 5. Tighten the

SETSCREW (5) to secure SPOUT ASSEMBLY (4) to mounting FLANGE (1). Re-attach ESCUTCHEON/O-

RING (3) to mounting FLANGE (1) until flush against finish wall.

6. Remove AERATOR (7) from SPOUT ASSEMBLY (4). See Figure 6. Turn on water supply and check for leaks.

Repair as needed. Open valve and run water through SPOUT ASSEMBLY (4) to remove debris. Check for

leaks and make any final adjustments required. Re-attach AERATOR (7) to SPOUT (4).

Figure 4

4

3

1/2”

MAX

Ø1-3/16”

(30mm)

Face of tile

1/2 NPT

(not included)

Figure 1

Stud supports

for mounting

Flange

1-1/2” MAX

Figure 3

1

3

Figure 5

4

5

1

3

Figure 6

7

4

2001 CARNEGIE AVE, SANTA ANA CA 92705

(949) 417-5207

WWW.NEWPORTBRASS.COM

NWP-9481 Rev E

EN-3

881a

11/07/19

1
2

Newport Brass 1030-5503/01 Installation guide

Brand: Newport Brass

Model: 1030-5503/01

Category: Sanitary ware

Type: Installation guide

Download PDF

Related papers

Other documents