Cetacea Sound Astronaut CL Soundfield Operating instructions

Type
Operating instructions

This manual is also suitable for

Astronaut Soundeld
Wireless Voice Amplication System
PAIRING INSTRUCTIONS
© 2018 Cetacea Sound Corp. All rights reserved.
Astronaut
TM
is a trademark of Cetacea Sound Corp.
(800) 556-1922 [email protected]om www.cetaceasound.com
Orbiter Pairing Instructions
1) Make sure the Orbiter pendant transmitter has been properly charged
and is NOT connected to the charger.
2) The Orbiter transmitter must be ON in order to pair (green LED)
3) The Astronaut Soundeld must be ON in order to pair (green LED)
4) Straighten the end of a medium paper clip.
5) Insert the end of the paper clip approximately ¹/
16
" (1.5 mm) into the
pairing hole on the Astronaut Soundeld speaker. Use a light press when
inserting the paper clip not to damage the hardware. The amber light will begin
to ash indicating that it’s in pairing mode.
6) Insert the end of the paper clip approximately ½” (1.3 cm) into the pairing hole
on the transmitter. Use a light press when inserting the paper clip not to
damage the hardware. Successful pairing will result in a solid amber light on the
Astronaut Soundeld.
7) Receiver pairing mode lasts only a short time. If unsuccessful, repeat steps
5 and 6.
Orbiter Pendant Transmitter
Astronaut Soundeld Speaker
ASTRONAUT SOUNDFIELD
PAIRING HOLE
TRANSMITTER
PAIRING HOLE
  • Page 1 1

Cetacea Sound Astronaut CL Soundfield Operating instructions

Type
Operating instructions
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI