© 2012 Cetacea Sound Corp. All rights reserved.
Orbiter™ is a trademark of Cetacea Sound Corp.
(800) 556-1922 [email protected] www.cetaceasound.com
All audio products are proudly made in the U.S.A.
4/12 201204-007
Orbiter Pairing Instructions
1) Make sure the Orbiter pendant transmitter has been properly
charged and is NOT connected to the charger.
2) Both the transmitter and receiver must be ON in order to pair.
Note: We recommend that the receiver is not plugged into the
speaker while pairing.
3) Straighten the end of a
medium paper clip.
4) Insert the end of the paper
clip approximately 1/16" (1.5
mm) into the pairing hole on
the receiver. Use a light press
when inserting the paper clip
not to damage the hardware.
The receiver amber light will
begin to fl ash indicating that
it’s in pairing mode.
5) Insert the end of the paper clip
approximately 1/2" (1.3 cm)
into the pairing hole on the
transmitter. Use a light press
when inserting the paper clip
not to damage the hardware.
Successful pairing will result in
a solid amber light on the front
side of the receiver.
6) Receiver pairing mode lasts only a short time. If unsuccessful, repeat steps 4 and 5.
Orbiter
WIRELESS PENDANT MICROPHONE
TRANSMITTER
PAIRING HOLE
15V DC
PWR
VAR
LINE
1
2
3
ORBITER
EXT. ANT.
INPUTS
OUTPUTS
1
2
3
INPUTS
RECEIVER
PAIRING HOLE
Pairing Instructions
-
1
Cetacea ASTRO-XLW001-SFC Operating instructions
- Type
- Operating instructions
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Cetacea Sound Astronaut XL Soundfield Operating instructions
-
-
-
Cetacea Sound Orbiter, V1 Quick start guide
-
-
-
-
-
Zenith Z42PX2D Series Installation guide
-