INSTALLATION INSTRUCTIONS
Remove the existing windshield hinges starting with
the top half of the windshield hinge. It will take two
p
eople to remove and install the bolts in the lower
half of the windshield hinge. One person must get
their hand up inside and hold the hex nut with a ½”
wrench, while the other person removes the bolts
from the outside. The driver side is harder to get at
the hex nuts because of all the wiring and emergency
brake bracket being in the way. Once the factory
hinges are removed, you can install the stainless steel
windshield hinges using the stainless steel bolts
p
rovided. Install the bolts in the upper half first. Start
all four bolts then snug them but don’t tighten at this
time. Again two people will be required to install the
b
olts in the lower half. First get all four bolts and nuts
started, then tighten all the lower half bolts. Finish by
tightening the bolts in the upper half.
NOTE: We recommend that you use anti-sieze on
all threads of the stainless bolts provided with
your parts.
PART NUMBERS 30403 & 30427 & 50403
Tools Required:
Assorted TORX and Hex Bits
½” Wrench
¼” or 3/8” Drive Ratchets
INSTALLATION INSTRUCTIONS
PART NUMBERS 30403 & 30427 & 50403
Remove the existing windshield hinges starting with
the top half of the windshield hinge. It will take two
p
eople to remove and install the bolts in the lower
half of the windshield hinge. One person must get
their hand up inside and hold the hex nut with a ½”
wrench, while the other person removes the bolts
from the outside. The driver side is harder to get at
the hex nuts because of all the wiring and emergency
brake bracket being in the way. Once the factory
hinges are removed, you can install the stainless steel
windshield hinges using the stainless steel bolts
p
rovided. Install the bolts in the upper half first. Start
all four bolts then snug them but don’t tighten at this
time. Again two people will be required to install the
b
olts in the lower half. First get all four bolts and nuts
started, then tighten all the lower half bolts. Finish by
tightening the bolts in the upper half.
NOTE: We recommend that you use anti-sieze on
all threads of the stainless bolts provided with
your parts.
Assorted TORX and Hex Bits
½” Wrench
¼” or 3/8” Drive Ratchets
Tools Required:
-
1
Kentrol 30427 Installation guide
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Factory Five Racing Mk3 Roadster Assembly Manual
-
Factory Five Racing Mk4 Roadster Assembly Manual
-
Era Replica Automobiles 427 ROADSTER User manual
-
Curtis Cab User manual
-
Bull Dog BD300A User manual
-
SIG SIGRC67 User manual
-
Seagull SEA238 User manual
-
American Sportworks TW265 Operating instructions
-
-
Seizmik 50-50222KIT User manual
