The Wall Bracket should be mounted to a sturdy, reinforced wall (e.g. concrete wall, brick
wall, wood-framed wall, etc.) The Wall Bracket is designed to work with standard 16” stud
spacing. Wall anchors can be used if mounting on drywall. This template indicates the proper
drill holes and the full, assembled size of the Wall Bracket.
Wall Bracket Template
.5"
13 mm
.5"
13 mm
16"
406 mm
8"
203 mm
8"
203 mm
4"
102 mm
4"
102 mm
Supercell Wall Bracket Template
#ZBT040001
Drill Here Drill Here
Drill Here Drill Here
LEVEL THIS LINE
The Cyclone can be rotated in 90-degree increments so that the inlet is facing parallel or
perpendicular to the wall. Decide how you want your system oriented during installation to
best meet your shop’s needs. Other positions will not work as they will hinder installation of
the Rear Support Brace.
Cyclone Mounting Positions
RIGHTFORWARD LEFT
Rev: 07/26/2019
/
