S.R.Smith Snap-Lok Pool Ladders Installation guide

06-910 OCT 2011

SNAP-LOK ANCHOR (60-713)

INSTALLATION INSTRUCTIONS

1. Install and secure the snap-lok anchor base into an existing anchor socket

and secure by inserting anchor bolt through hole in snap-lok anchor base,

into the wedge in the anchor, and tighten.

2. When retrofitting a snap-lok anchor onto a standard ladder, the bottom 4”

of tube must be cut off of the ladder posts that would normally go into the

anchor socket. Drill two 3/8” holes as shown. (See fig. 1)

(Fig. 1)

Double button snap lock should be inserted into bottom of ladder posts,

and seated into top hole. Secure the ladder to the anchor by inserting 2-

1/2” bolt through bottom hole in ladder, and tighten with flat washer and

acorn nut.

WESTERN SALES AND MANUFACTURING PLANT

CORPORATE HEADQUARTERS

P.O. Box 400  1017 S.W. Berg Parkway

Canby, Oregon 97013

Phone (503) 266-2231  Fax (503) 266-4334

EASTERN MANUFACTURING PLANT

105 Challenger Drive

Portland, Tennessee 37148

Phone (615) 325-0770  Fax (615) 325-0775

www.srsmith.com

Cut 4” from bottom

of each vertical post.

Drill (2) 3/8” holes.

3/8” hole – 2.375” from

bottom of leg.

3/8” hole - .875” from

ottom of leg.

Download PDF