Page is loading ...
Page is loading ...
“Made for iPod,” “Made for iPhone” and “Made for iPad” mean
that an electronic accessory has been designed to connect
specically to iPod, iPhone or iPad respectively, and has been
certied by the developer to meet Apple performance stand-
ards. Apple is not responsible for the operation of this device
or its compliance with safety and regulatory standards.
iPhone, iPad and iPod are trademarks of Apple Inc., registered
in the U.S. and other countries.
FCC Information (for US customers)
1. Product
This product complies with Part 15 of the FCC Rules. Op-
eration is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
2. Important notice:
DO NOT MODIFY THIS PRODUCT
This product, when installed as indicated in the instruc-
tions contained in this manual, meets FCC requirements.
Modication not expressly approved by ARCAM may void
your authority, granted by the FCC, to use the product.
n
Zendt uw muziek en geluiden draadloos vanaf uw
Apple iPod®, iPhone® of iPad™ naar Arcam pro-
ducten die deze toepassing ondersteunen.
Instellingen voor het eerste gebruik
1. Plaats de zender in de iPod/iPhone/iPad
2. Druk op de ‘Associate’ toets en houd deze 3
seconden ingedrukt
3. Houd de toets aan de onderkant van de rWand
ingedrukt en laat deze los zodra status LED snel
begint te knipperen (5 keer per seconde).
4. Activeer de ‘Associate’ mode op het ontvan-
gende product (zoals de rDAC of de rCube) –
zie de handleiding van het betreende product
voor meer details
5. Wanneer de koppeling geslaagd is kan u uw
muziek afspelen
6. Het tot stand brengen van deze koppeling is
alleen noodzakelijk wanneer de zender voor
het eerst in gebruik genomen wordt.
, .
;4
23425
5 060133 601999
E999PK_1
®
iPhone, iPad and iPod are trade-
marks of Apple Inc., registered in
the U.S. and other countries.
23425 rWand
+
Sends music and sounds wirelessly to supported
Arcam products.
Made for: iPhone 3GS, iPhone 3G, iPhone 4
Made for iPad™
Made for iPod touch (3rd and 4th generation)
Made for iPod classic (6th generation)
Made for iPod nano (5th and 6th generation)
Initial Setup:
1. Insert device into iPod/iPhone/iPad
2. Press and hold ‘Associate’ button
within 3 seconds
3. Wait until status LED ashes
rapidly (5 times per second)
then release button
4. Activate association mode on
receiving product(s) (e.g. rDAC,
rCube) — see product handbook
for further details
5. When association is complete,
play songs.
Association is only required the rst time
that the transmitter is used with a particular
receiver product.
Problems or questions?
Please contact your dealer. If your Arcam dealer is
unable to answer any query regarding this or any
other Arcam product please contact Arcam
Customer Support at the address below:
Customer Support Dept.
ARCAM
Pembroke Avenue
Waterbeach, Cambridge
CB25 9QR
http://www.arcam.co.uk
/
