
www.aleratec.com
3
Using the HDD Copy Cruiser Mini
Duplicating Hard Drives
1. UsetheincludedpoweradapterandcordtoplugtheHDDCopyCruiserMiniinto
apoweroutlet.
2. InserttheSATAHardDriveyouwanttocopyintotheslotmarked“SOURCE”.
Wheninserting,aligntheSATAportontheHardDrivewiththeSATAconnectorin
thedrivebayslot.
3. InsertthedestinationSATAHardDriveintotheslotmarked“TARGET”.When
inserting,aligntheSATAportontheHardDrivewiththeSATAconnectorinthe
drivebayslot.
Note: Make sure the target Hard Drive has the same or higher capacity than your
source Hard Drive. The duplication process will not start if the target drive has
a lower capacity. Also make sure the unit is not connected to a PC through the
USB port.
4. PowerontheHDDCopyCruiserMini.
5. PressandholdtheCopybuttonfor5secondsandrelease.TheSourceindicator
lightwillturnonandtheTargetindicatorlightwillash.PushtheCopybutton
againtobegintheduplicationprocess.Therststatusbarindicatorlightwillbegin
ashingwhenthecloneprocessstarts.
Note: Pressing the Start button will also erase all data on the target drive.
6. Theduplicationprocessiscompletewhenthestatusbarreaches100%andstops
blinking.
7. PowerofftheHDDCopyCruiserMinitoremovetheharddrives.