Page is loading ...
T E C H N O L O G I E S
Technical Support
If you need any assistance to get your unit functioning properly, please have your
product information ready and contact Addonics Technical Support at:
Hours: 8:30 am - 6:00 pm PST
Phone: 408-453-6212
Email: http://www.addonics.com/support/query/
www.addonics.com
User Guide
Internal mSATA SSD /
CFast card Reader/Writer
(MSCFASA, MSCFA2SA)
www.addonics.com
Phone: 408-573-8580
Fax: 408-573-8588
Email: http://www.addonics.com/sales/query/
CONTACT US
Power & Drive
Activity LED
SATA port
4 pin floppy
power connector
LED information
The Power & Drive Activity LED glows green to indicate power and
blinks red to indicate drive activity.
Unpacking and Overview
mSATA Adapter
CFAST Adapter Micro SATA DigiDrive
(MSCFASA)
18” SATA Cable
(MSCFA2SA: Qty 2)
Dual Micro SATA DigiDrive
(MSCFA2SA)
Installation
1. Slide your mSATA SSD into the adapter.
2. Install the adapter and card into the mounting bracket as shown.
3. Completed assembly is suitable for mounting the same way as
a 2.5” hard disk, including connector position and mounting taps.
Hot Swapping
This unit supports hot swapping (inserting or removing drives
while the drives are running and connected to a computer).
The SATA controller on the computer must also support hot
swapping - be sure to confirm this before attempting to insert or
remove drives while the system is running.
Also be sure to practice the appropriate safe removal procedure
before proceeding. Failure to practice safe removal procedures
will result in loss or corruption of data.
/
