Bon Tool 11-850 Operating instructions

Brand: Bon Tool

Model: 11-850

Type: Operating instructions

Bon Tool 11-850 is a safety shield for a tuck pointing router bit. It comes with three reducing rings to fit on different machines and a spanner. The safety shield helps to protect the user from dust and debris when using a tuck pointing router bit. It also allows the user to adjust the depth of the cut. The safety shield is easy to fit and remove, and it is compatible with all Bon® tuck pointing router bits.

Here are some of the features and possible use cases of the Bon Tool 11-850:

Protects the user from dust and debris: The safety shield helps to protect the user from dust and debris when using a tuck pointing router bit. This is important because dust and debris can be harmful to the user's health.

Here are some of the features and possible use cases of the Bon Tool 11-850:

Protects the user from dust and debris: The safety shield helps to protect the user from dust and debris when using a tuck pointing router bit. This is important because dust and debris can be harmful to the user's health.

THIS BOX CONTAINS THE FOLLOWING:

• A safety shield for a tuck pointing router bit.

• Three reducing rings to fit on different machines.

• A spanner.

FITTING THE SAFETY SHIELD

When fitting and removing the safety shield for tuck

pointing router bits and when working on tuck pointing

router bit themselves, the angle grinder MUST NOT be

connected to any form of energy or power supply.

1. Take the safety shield and loosen the bottom screw

with the spanner.

2. Turn the upper half of the safety shield 45

counter-clockwise (i.e. to the left) so that the vacuum

cleaner outlet faces the opening in the side of the

lower half of the safety shield.

3. Tighten the bottom screw with the spanner.

4. Remove the shield attached to the angle grinder.

5. Remove the locking rings for the grinder discs.

6. Fit the safety shield to the angle grinder (using a

reducing ring if necessary) and carefully tighten the

upper most screw.

7. Fit the tuck pointing router bit. ONLY tuck pointing

router bits made by Bon

should be used.

8. It is now possible to adjust the depth of the tuck

pointing router bit. To do this, loosen the bottom

screw and pull the bottom part of the safety shield

down no more than 3/4”. Remember to re-tighten

the bottom screw carefully after adjustment.

ALWAYS REMEMBER:

• Use a dust mask.

• Use protective eyewear that provides protection

against dust.

• Use ear protectors.

• Use gloves that dampen vibration.

• Use vacuum removal systems designed to deal with

dust from the material with which you are working.

USING THE SAFETY SHIELD

1. This safety shield may ONLY be used with mortar

routers made by Bon

2. When using the complete unit (safety shield and

angle grinder), keep one hand on the vacuum

connection on the safety shield, and one hand on

the angle grinder.

3. It is recommended to start work on the lowest

section of the mortar joints, moving from left to right;

and then advance to the next section of joints above

and reverse direction, moving from right to left.

4430 Gibsonia Rd. • Gibsonia, PA 15044 • USA • www.bontool.com

IS11850 04/2013

INSTRUCTIONS

#11-850 Safety Shield

Depth Gauge for Mortar Router

Bon Tool 11-850 Operating instructions

Brand: Bon Tool

Model: 11-850

Type: Operating instructions

Here are some of the features and possible use cases of the Bon Tool 11-850:

Protects the user from dust and debris: The safety shield helps to protect the user from dust and debris when using a tuck pointing router bit. This is important because dust and debris can be harmful to the user's health.

Download PDF

report

Bon Tool 11-850 Operating instructions

Bon Tool 11-850 Operating instructions

Related papers

Other documents