Bon Tool 11-894 Operating instructions

Applications

- Masonry expansion wall joints

- Precast panel wall joints

- Pavement/Floor Joints

- Drive-It/Stucco

Assembly

1. Locate the main frame.

2. Select the desired insertion wheek size. Insert shaft into main

frame.

3. Insert Vibration Resistant thumb screw.

4. Adjust insertion wheel to desired depth.

Tighten vibration resistant screw until secure contact is made with

flat on shaft.

Accomodates a standard threaded broom handle when desired.

Head of thumb screw can be used to start backer rod and to pitch

off backer rod at end of insertion.

INSTRUCTIONS

#11-890 Adjustable Back Rod Installer

IS11890 5/15

4430 Gibsonia Rd. • Gibsonia, PA 15044 • USA • www.bontool.com