Page is loading ...
17-0523 12/12/12
1
17-0523 12/12/12
2
Section 2 Installation Instructions
Part Number 5028106 012/08 2-5
PLUMBING DIAGRAMS
Install the beverage tubing to the appropriate fittings. Refer to the cold plate drawing on the front of the chest for your
individual set up. See the example below of how your Beverage Ice Chest may be hooked up.
CLEAN UP
Clean up all work areas. Dispose of all packing material,
excess tubing and trash properly.
17-0523 12/12/12
3
5028005-1
5028083-0
5028006-0
About the Bins
• Model 1522 Ice Storage Capacity: 60 lbs. (27.27 kgs)
• Model 2123 Ice Storage Capacity: 80 lbs (36.36 kgs)
• Freestanding and drop-in versions offered with and without cold plates.
• Two-piece stainless steel sliding lid.
• 6’ Anti-Microbial drain line tubing.
Unit Inspection
This section covers unpacking, inspecting, selecting location, installing the unit, and
preparing for operation. Thoroughly inspect the unit upon delivery. Immediately report
any damage that occurred during transportation to the delivery carrier. Request a
written inspection report from a claims inspector to document any necessary claim.
Installation Instruction
• Remove components from bin.
• Remove ice chest from box, lay on side on a soft surface.
• Attach 6’ Anti-Microbial drain line tubing with clamp provided.
• Remove leg set top frame from box.
• Assemble knock down leg set (see instruction next page).
• Place ice chest on assembled leg set (be sure to center on the top frame).
17-0523 12/12/12
4
17-0523 12/12/12
5
/