Legrand Telecom Surge Conditioning Unit, IS-0209 Installation guide
- Type
- Installation guide
301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
Page 1 of 2
INSTRUCTION/INSTALLATION SHEET
TELECOM SURGE CONDITIONING UNIT
IS-0209 REV. A
©Copyright 2006 by On-Q/Legrand All Rights Reserved.
1. Introduction
The On-Q/Legrand Telecom Surge Conditioning Unit, PN
364600-01, provides surge protection for up to four (4)
incoming telecom service lines. The Telecom Surge
Conditioning Unit mounts to an On-Q Telecom Service
Conditioning Module, PN 364599-01, which can be mounted
into any On-Q style enclosure. See Figure 1.
2. Description
The Telecom Surge Conditioning Unit is a green unit with a
captive mounting screw for mounting to the Service
Conditioning Module. The unit has two (2) RJ45 connectors
for interfacing to the telephone distribution network. The unit
is packaged with a six inch Cat 5e Jumper (PN 363201-27).
3. Installation
A. Mounting the Unit to the Service Conditioning Module
(see Figure 2)
1. Install the Telecom Service Conditioning Module in
Enclosure per instructions included with module (ref.
IS-0204).
Note: The Enclosure and module must be properly
installed and grounded for Surge Conditioning Units
to function.
2. Position the unit on the module by aligning the tab
on the housing with one of the three (3) recess cuts
on the module.
Note: Up to three (3) Conditioning Units may be installed, in series, on a single module. It is
recommended that the Surge Unit be the first unit in series from the incoming service.
3. Align the captive screw with the appropriate threaded insert. Use a Philips screwdriver to attach unit to
the module.
B. Connecting to the Telecom Network (see Figure 3)
1. Incoming Service is to be terminated into an RJ45 plug. This may be through an EZ-RJ45 Modular Plug, PN
364554-01, being terminated to the incoming service cable; or, by using a Cat 5e Jumper cable from the
service, terminated to an RJ45 interface, such as the On-Q Network Interface, PN 363486-01.
2. Connect the Line Out to the Telephone Distribution System or the next Conditioning Unit in series. Use the
Cat 5e Jumper provided.
Figure 1
Figure 2
301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
Page 2 of 2
INSTRUCTION/INSTALLATION SHEET
TELECOM SURGE CONDITIONING UNIT
IS-0209 REV. A
©Copyright 2006 by On-Q/Legrand All Rights Reserved.
Figure 3
-
1
-
2
Legrand Telecom Surge Conditioning Unit, IS-0209 Installation guide
- Type
- Installation guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Legrand DSL Splitter Conditioning Unit, IS-0210 Installation guide
-
-
-
-
-
-
-
-
-
