2. Tivoli
  3. 5952

Tivoli 5952 User manual

  • Hello! I've reviewed the Regulor LED lighting guide and understand its features such as adjustable beam angles (10°, 30°, 60°, 90°) and various Tivotape options. I know about different mounting accessories and end cap options. Feel free to ask me any questions you have about this product.
  • What are the available beam angles for the Regulor channel?
    What are the available Tivotape options?
    What mounting accessories are available for the Regulor channel?
REGULOR
Ceiling Wall
GUIDE Regulor
www.tivolilighting.com tel: 714-957-6101 fax: 714-427-3458
Page 2 of 3
Copyright © Tivoli 04/14/23
Tivoli, LLC. reserves the right to modify this specication without prior notice.
ORDERING INFORMATION
PROFILE DIMENSIONS
AVAILABLE TIVOTAPE™ OPTIONS
2400K2200K 2700K 3000K 3500K 4000K 5000K
SB
3 W/ft
HO
4.4 W/ft
LB
1.4 W/ft
RGBmini
4.4 W/ft
RGBW
5.3 W/ft
RGLR-CHAN-6.5
Anodized aluminum channel
with adjustable beam angle
10°, 30°, 60°, 90°
S-LNS-LF-6.5
Clear lens
RGLR-EC-01
End-cap (without hole)
RGLR-EC-02
End-cap (with hole)
.446
.436
.627
.315
.690
GUIDE Regulor
www.tivolilighting.com tel: 714-957-6101 fax: 714-427-3458
Page 3 of 3
Copyright © Tivoli 04/14/23
Tivoli, LLC. reserves the right to modify this specication without prior notice.
MOUNTING ACCESSORIES
AVAILABLE BEAM ANGLE
RGLR-ADJ-MTBK
Adjustable Mounting bracket
Polycarbonate UV Stabilized
MTBK-01
Mounting Bracket Zinc
MTBK-02
Mounting Bracket Chrome
Option 1: 10° Beam Angle
This option does not use the included insert.
Step 1: Cut Tivotape™ at recommended cut point, if necessary, to t channel.
Step 2: Peel o backing tape and apply Tivotape™ directly to the inside surface of Regulor Channel.
Option 2: 30° and 60° Beam Angle .
Step 1: Position the Channel Insert with the shallow side up.
Step 2: Make sure insert surface where Tivotape is to be applied is clean, free of all dirt, oil and
debris.
Step 3: Peel backing tape from bottom side of Tivotape™ and attach to shallow surface of insert.
Step 4: Slide insert into channel as shown.
Use lower slot in Channel to achieve a 30° beam angle and use the upper slot for a 60° beam
angle.
Option 3: 90° Beam Angle.
Step 1: Position the Channel Insert with the deep side up.
Step 2: Make sure surface of insert where Tivotape is to be applied is clean, free of all dirt, oil and
debris.
Step 3: Peel backing tape from bottom side of Tivotape™ and attach to deep surface of insert.
Step 4: Slide insert into upper slot of channel as shown.
0.87in
1.58in
1.13in
150
90
1.84in
0.77in
1.34in
0.87in
1.58in
1.13in
150
90
1.84in
0.77in
1.34in
/