2. Garth
  3. Fascia Set Replacement
Fascia Set Replacement

Garth Fascia Set Replacement Operating instructions

  • I have reviewed the user manual for the fascia Set. The document provides step-by-step instructions on how to disassemble and replace the fascia set, including the removal of bolts, screws, and the side burner ignition wire. I am ready to answer your questions about the fascia replacement process based on the manual's content.
  • What is the first step in replacing the fascia set?
    How many bolts need to be removed from the side burner shelf?
    What needs to be loosened on the front fixing screws?
How to replace the fascia Set
Step 1: Pull out the side burner ignition wire.
Step 2: Take out the three bolts on either side of the side burner shelf as shown.
Step 3: Loosen the front fixing screws 3mm on either side of the side burner shelf,
as shown.
Step 4: Fold open the left side table
Step 5: Take out the three screws on the left side shelf, as shown below.
Step 6: Loosen the front fixing screws 3mm on the left side shelf, as shown below.
Step 7: Fold open the left side table
Step 8: Loosen the two sets of screws in the sides of the panel。
Step 9: Take out all the knobs.
Step 10: Remove all screws from the knob bezel.
Step 11: Loosen the set screws at the back of the panel
Step 12: Remove the panel
/