2. Crystorama
  3. 2249-BF-NOSHADE

Crystorama 2249-BF-NOSHADE User manual

  • Hello! I'm here to assist you with your CRYSTORAMA Chandelier. I've reviewed the assembly instructions for the 2249-BF_NOSHADE model, which provides guidance on how to assemble the chandelier. It covers steps including how to spread arms, attach loops, mounting plate and canopy, also highlights use of 8 candelabra base bulbs and specifies that the fixture is Dry rated. I’m ready to answer any questions you have about its assembly or features.
  • How many bulbs are needed for this chandelier?
    Is this fixture suitable for wet locations?
    Can I use LED bulbs?
ASSEMBLYINSTRUCTIONMODEL#2249-BF_NOSHADE
CRYST
RAMA
WARNING:
ElectricalDanger TurnPoweroff
WARNING: ThisproductcanexposeyoutoLead
whichisknowntothestateofCaliforniatocausecancer
and/orbirthdefectsorreproductiveharm.Formore
informationgotowww.P65Warnings.ca.gov
L I G H T I N GT H EW A YF O RS I X T YY E A R S
installedbyalicensedelectrician
inaccordancewiththeNational
Allelectricalcomponentsmustbe
ElectricCodeandtheappropriate
localelectricalcodes.
Howtoinstall
9.Installthebulbs(notincluded)intothesocket.
Youwillneed8-CandelabraBaseBulb
40WattsRecommended60WattsMax.
USELEDBULBSFOREXTENDEDUSE
This fixture is Dry rated
8.Installthefabricshadeontothecandlesleeve.
2.Sliptheloopalongwireandthreadontothenipple
ofarmassembly.
1.Removethescrewfromeachoftheholesonthemetal
frame.Aligntheholesonthetabsofthearmassembly
withtheholesonthemetalframeandsecuretogether
usingthescrewsthatwereremoved.
SPREAD THE ARMS TO A SUITABLEPOSITION
OUTLET BOX SCREW
LOOP
WALL ANCHOR
ANCHOR SCREW
MOUNTING PLATE
MOUNTING SCREW
CANOPY
CHAIN
LOOP
NIPPLE
ARMS SCREWS
(Thescrewsfrommetalframe)
METAL
FRAME
BOTTOMFINIALS
3.Placethemountingplateovertheoutletbox.Mark
fourpointsontheceilingatthecenterofthekeyhole
onthemountingplate.
4.Drillfourholesatthemarkedpointsandinsertthe
wallanchors.
5 Placethemountingplateovertheoutletboxand
secureitwithtwooutletboxscrews.Insertthe
anchorscrewsintothewallanchors
(Installedinstep#5)andtighten.
.
6.Determinethepreferredhangingheightandadjustto
thechainrequired.
7.Installcanopyontothemountingplate,andsecure
withthemountingscrews.
25’’
21-1/4”
3/4’’
42’’
147-3/4’’
4-1/2”
18’’
FABRIC
SHADE
4’’
3’’
4-1/2’’
FABRIC SHADE
CANDLE
SLEEVE
(Optional)
Crystorama.com
CRYST
RAMA
L I G H T I N GT H EW A YF O RS I X T YY E A R S
ASSEMBLYINSTRUCTIONMODEL#2249-BF_NOSHADE
Part Number
PartNumbers
A.(1)-Mounting hardware
B.(1)-Mountingplate
C.(4)-Mountingscrew
D.(1)-CanopyW4-1/2’’xL21-1/4’’xH3/4’’ #XRF2249BFCAN21.25IN
E.(4)-Loop
F.(2)-Chain-120’’,4mmthick#XRF2248BFCHA4.0MM
G.(8)-Screw
H.(1)-Metalframe
I.(4)-Bottomfinial
J.(8)-FabricshadeW4’’xH4-1/2’’ #XRF2243SHA4.5IN
K(A).(8)-Candlesleeve-BFW7/8’’xL2-3/8’’ #XRF2243BFCDL2.375IN
K(B).(8)-Candlesleeve-WHW7/8’’xL2-3/8’’ #XRF2243WHCDL2.375IN
A
B
C
D
E
F
E
G
H
I
J
K
Crystorama.com
/