2. Merra
  3. HCF-4037-CH-BNHD-1
HCF-4037-CH-BNHD-1

Merra HCF-4037-CH-BNHD-1, 22 Inch LED Vanity Light, HCF-4036-BK-BNHD-1, HCF-4036-CH-BNHD-1, HCF-4037-BK-BNHD-1 User manual

  • Hello, I'm your chat assistant. I have reviewed the installation instructions for the HCF-4036-BK and HCF-4036-CH lamps. This document provides detailed instructions on safe and proper installation, including electrical wiring and mounting steps. I am here to answer any questions you may have about the content of these instructions.
  • What should I do before installing the lamp?
    What is the maximum wattage for the SMD LED light plate?
    What do I need to connect the mounting bracket to the junction box?
V20220377
ASSEMBLY
1. Prepare the wiring in your wall for the desired location of your new lamp. Prepare your
junction box (not included).
2. Removethecanopybolts(D)andtakethemountingbracket(A)othecanopy(E).
3. Connect the mounting bracket to your junction box using the mounting bolts (B).
4. Make electrical connections using the wire nuts (C).
5. Being careful that no wiring is left exposed, place the canopy against the mounting bracket
and replace the canopy bolts.
6. Turn on your lamp and enjoy!
Contact Us
Thank you for choosing our products! If you have any questions or
comments, contact us at [email protected] and we'll resolve
your issue ASAP!
For a .pdf copy of the latest version of these instructions, use the
appropriate app on your smartphone to scan the QR code to the right.
WARNING!
Read these instructions carefully prior to installation.
• Check for electric, gas, and plumbing lines before drilling or consult a professional.
• ALWAYS cut ALL relevant power before installing a lighting fixture and do not
restore power to the line until the lamp has been FULLY installed.
• DO NOTuseanySMDLEDlightplateexceeding5W.
INSTRUCTIONS
Canopy(E)
Junction Box
Mounting Bracket (A)
Mounting Bolt (B)
WireNut(C)
Canopy Bolt (D)
HCF-4036-BK HCF-4036-CH Rev. 13 Apr. 2022
/