2. Vista
  3. 1051KM Architectural Series Linear LED Floodlight

Vista 1051KM Architectural Series Linear LED Floodlight User manual

  • Hello! I've reviewed the installation instructions for the Vista Professional Outdoor Lighting Architectural Series LED Floodlights (1051KM, 1052KM, and 1054KM). This guide covers the knuckle mounting process, wiring, and aiming of the fixture. I am ready to answer your questions about this product.
  • What type of installation is this luminaire designed for?
    What should I do before starting luminaire installation?
    What should I connect the luminaire supply conductors to?
INSTALLATION INSTRUCTIONS
1625 Surveyor Avenue • Simi Valley, CA 93063 • (805) 527-0987 • (800) 766-VISTA (8478) • FAX: (888) 670-VISTA (8478) • [email protected] • www.vistapro.com
Vista Professional Outdoor Lighting reserves the right to modify the design and/or construction of the fixture shown without further notification.
03/22
1 of 1
1. Make sure electrical supply is off at circuit breaker before starting
luminaire installation or servicing luminaire.
2. Thread SS Knuckle Stem into Junction Box Lid. Tighten fully.
3. Loosen the Knuckle Aiming Screw, rotate the Knuckle Stem to align
with SS Knuckle Stem.
4. Route luminaire supply conductors into wet location rated J-Box (by
others). Attach conduit supply conductors (by others) to the luminaire
conductors observing polarity, line to black, neutral to white, and ground
to green. Connect the supply / luminaire conductors using approved
wiring methods.
5. Secure the Junction Box Lid onto the Junction Box using the Junction
Box Lid Screws. Tighten.
6. Position the Knuckle Stem over the SS Knuckle Stem. Lock in place with
Knuckle Set Screw(s).
7. Adjust the aim of the fixture and firmly re-tighten the Knuckle Aiming
Screw(s).
8. Supply power to the luminaire and check for proper operation.
LUMINAIRE MOUNTING (KNUCKLE) TO JUNCTION BOX(ES):
Fixture Body
Linear LED Floodlight – Knuckle Mount
ArchitecturAl SerieS
1051KM / 1052KM / 1054KM
IMPORTANT NOTE:
• Luminaire must be installed and grounded in accordance with the National Electrical Code (NEC) and local codes.
• Luminaire is UL listed for above grade installation only.
• Always use UL recognized wire connectors for connections.
MAINTENANCE: To assure proper operation and efficiency, lens must be kept clean and free of dirt, dust,leaves, trash and mineral deposits from water.
A regular scheduled maintenance program is recommended.
SAFETY WARNING: Luminaire can become hot. Take care when locating luminaires.
NOTE: Save these instructions for future reference.
Knuckle Flange
Knuckle Stem
Junction Box Lid
Knuckle
Aiming
Screw
Knuckle
Set Screw
Knuckle Stem
Junction Box lid Screws (4)
Junction Box
/