Ampac 8 Way Switch & Indicator Module Installation guide

Ampac
Brand
Ampac
Model
8 Way Switch & Indicator Module
Type
Installation guide
MAN2493-2
Switch & Indicator Card Item Number: 4310-0030
Installation guide
Description
Controls and monitors ancillary equipment
Eight (8) push on / push off switches per card
Switches map to relays – requires Relay Board (Order
Code: 4310-0050)
One (1) status indicator per switch – requires Input
Board (Order Code: 4310-0040)
Programmed via the FACP front panel
The Switch Indicator Fast Card Fit Kit consists of:
• 1 x BRD25GIBB-‘X’
• 1 x 220mm and 350mm RJ45M Comms cable
Installation
Observe anti-static precautions at all times
1. Power down and disconnect the batteries.
2. One Switch and Indicator Card per FACP is
designed to clip into the front panel of the FACP.
3. From inside the FACP remove the blank panel by
depressing the 2 top and bottom retaining clips
while at the same time pushing it out through the
front panel. Insert labels and clip in the Switch
Indicator Card.
4. Select a suitable cable length from those supplied
to connect CN1 of the module to the CN9 of the
Main Card or, CN2 of the previous front panel card.
5. Power up, connect the batteries, program and test.
Card & PCB Securing Tabs
( Top & Bottom )
PCB
Clear Plastic Clip In Label
Clip on
Plastic Surround
( Push down here and pull
out to remove and insert labels )
Note: As per AS 1668
lettering on any of the
slip in labels must be
at least 5mm in height.
Windows for
Slip in Label
Slip In Label
WINDOWS FOR
SLIP IN LABEL
Figure 1: Switch & Indicator Card (See LAB1483.doc
for Slip In Label)
Termination Link
In Out
Address
Switch
Set to 1
1 2 3 4
ON
C
N
1
C
N
2
CN1: Communications & 27V IN
from CN2 off the previous Front
Panel Card or CN9 on the Main Card
CN2: Communications & 27V OUT to Next Front Panel Card.
If Unsed the Termination Link Must be Inserted.
Top Card &
PCB Securing Clips
Bottom Card &
PCB Securing Clips
Figure 2: Switch & Indicator Card PCB Layout
CN2 C N1
+27VDC
CN5
CN9
CN2
CN1
CN2 CN1
CN6
PO WER
+27 V
0V
CN1
CN2
POW ER
+27 V0V
CN1
CN2
MAIN CONTROL
CARD
PSU1887
CN3
CN4
CN3CN4
CN8 CN10
SWITCH & INDICATOR CARD
POWER
SUPPLY
RS485
PO WER
+27 V
0V
CN1
CN2
CN3
CN4
FRONT PANEL
BACKPAN
TO NEXT
FRONT
PANEL
CARD IF
APPLICABLE
Figure 3: Typical Switch and Indicator Card Cabling to the Main Control Card
  • Page 1 1

Ampac 8 Way Switch & Indicator Module Installation guide

Ampac
Brand
Ampac
Model
8 Way Switch & Indicator Module
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents