Raco Open Center Bracket Installation guide

Hello! I have reviewed the provided instructions for the Hubbell open center brackets, models 9016R and 9024R. The document details the installation process step-by-step, including the use of screws for support, rotating components, and bending tabs to secure cables and the electrical box. I'm ready to answer your questions about these steps or any other aspects of the brackets described in this document.
How many far side supports are needed?

What is the first step in the installation?

How much should the back center piece be rotated?

What should be done in step 5?

RA-349 Instr

400853

Hubbell Commercial Construction

Hubbell Incorporated (Delaware)

RACO®

3902 W. Sample St.

South Bend, IN 46619

Phone: (574) 234-7151 FAX (574) 283-4244

STEP 1.

Attach open center bracket

with (2) screws

Instructions for using RACO open center bracket

9016R and 9024R

A minimum of (1) far side support must be installed on each electrical box, to retain cUL listing in Canada

STEP 2.

Rotate back center piece almost

180° until it stops

STEP 3.

Install box and cables

STEP 4.

Rotate back top section 90°

STEP 5.

 Bend up tabs adjacent to the cables 90°

 Push back top section until it hits the cables

STEP 6.

 Bend down tabs adjacent to the cables 90°

 Bend side tabs 180°

 Bend side tabs 90°

STEP 7.

 Bend side tabs back 90°

 Install screws as shown





