2. Raco
  3. 119046 RA-363

Raco 119046 RA-363 Installation guide

  • I have reviewed the provided instructions for the RACO Prefab Far Side Support. This document details how to install the support for various stud depths using tab bending. I'm ready to answer any questions you have about it.
  • What stud depths are compatible with this support?
    Do I need to adjust the support for 2-1/2" studs?
    Are the back knockouts usable with the FS support?
RA-363 Instr
119046
Hubbell Commercial Construction
Hubbell Incorporated (Delaware)
RACO®
3902 W. Sample St.
South Bend, IN 46619
Phone: (574) 234-7151 FAX (574) 283-4244
Instructions for using RACO Prefab
Far Side Support
For 2-1/2" deep studs.
Comes preset.
NOTICE: Back knockouts are NOT usable with the FS support
on certain stud depths.
For 3-1/2" deep studs.
Bend center tab as shown
in 2 places.
For 3-5/8" deep studs.
Bend center tab as shown.
For 4" deep studs.
Bend center tab as shown.
For 5-1/2" deep studs.
Bend both tabs as shown.
For 6" deep studs.
Bend both tabs as shown.
/