Golden Lighting 2360-4 CH Installation guide

Type
Installation guide

This manual is also suitable for

Assembly Instructions: 2360-4/6 (Garvin)
IMPORTANT:
• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.
• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!
• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!
CLEANING TIPS
Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the
xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.
For Customer Service, contact
the place of purchase.
PREPARING FOR INSTALLATION
Remove all of the contents from the carton. See the important notes above. Shut off the power
atthecircuitbreakerandcompletelyremovetheoldxturefromtheceiling,includingtheold
mountingstrap.
Fromthepartsbagremovethemountingstrapassembly.Oneendofnipple(G)shouldbe
attachedtomountingstrap(A)withwasherandhexnut(CandF)inplace.Theotherend
shouldhavecanopyloop(H)attached.Matchthethreadedholesofmountingstrap(A)to
thespacingoftheholesonthejunctionbox.Attachmountingstrap(A)tothejunctionbox
usingmountingscrews(B)andascrewdriver.Tightensecurely.Unscrewcanopyloopcollar
(I)fromcanopyloop(H).Passcanopy(D)overthemountedcanopylooptotesttheheight.
Approximatelyhalfofthecanopyloop’sexteriorthreadsshouldbeexposed,andcanopyloop
collar(I)shouldtsnuglyontothecanopyloop.Removecanopy(D)andadjusttheheightof
nipple(G)andcanopyloop(H)untilthedesiredheightisreached.
Smooth / Black /
Transparent (L)
Black (Hot)
Ribbed / White /
Transparent (N)
Bare Copper / Transparent with
Green Interior / Green
White (Neutral)
Green
(Ground)
FINISHING THE INSTALLATION
Pushcanopy(D)uptotheceilingandslidecanopyloopcollar(I)upbeneaththecanopy.Tightlythreadcanopyloopcollar(I)onto
canopy loop (H) to secure canopy (D) in place. Slide candle sleeves (U) over sockets (T). Install bulbs (N - not provided) into sockets (T) in
accordancewiththexture’sspecications.Donotexceedthemaximumwattage.Yourinstallationisnowcomplete.Turnonthepower
andtestthexture.
ASSEMBLING THE FIXTURE
Haveanassistantsupportthexture’sweightanduseloops(R)ofconnectorrods(L)toattach
theconnectorrodstohooks(Q).Rods(O)areonthexture’swires,butnotconnectedtothe
xture.Bymeasuring,determinethecorrectnumberofrodsandchainneededforproper
hangingheight.Tolengthenthexture,addadditionalrodsorchain.Ifadditionalrodsare
needed,contacttheplaceofpurchasetoorder.Toshortenthexture,trimthewirestothe
desiredlengthaddingatleast8to10extrainchestothatlength.Slideanyexcessrodsoffthe
xture’swirestodiscard.Threadthewiresthroughtherodsandpullthewiresuntiltautbefore
threadingtherodstogether.Threadbottomrod(O)ontopost(P).Attachtoploop(M)tothetop
of top rod (O).
Ifnecessary,useapairofplierstoopenandremoveanyexcesschain.Attachoneofchain
connectors (K) to each end of chain (J). Use one of chain connectors (K) to attach chain (J) to
toploop(M)andclosethechainconnector.Feedthexture’swiresupthroughthechain(every
threelinksorso),pullingthewiresuntiltaut.Slidecanopyloopcollar(I)andcanopy(D)ontothe
chain and wires. Use the free chain connector (K) to attach chain (J) to canopy loop (H).
A
B
C
D
E
F
G
H
I
J
K
M
O
P
S
T
U
Q
R
L
N
CONNECTING THE WIRES
Haveanassistantsupportthexture’sweightwhile
completingthewiring.Cutawayexcesswires.Threadthe
xture’swiresthroughcanopyloopandnipple.Attachthe
xture’swirestothepowersupplywiresfromthejunctionbox.
Connect black to smooth/black/transparent (L) wire; white to
ribbed/white/transparent(N)wire;groundtoground(greenor
copper).Twisttheendsofthewirepairstogether,andthen
twist on a wire connector. Make sure all twists are in the same
direction.Ifthereisnogroundwire(greenorcopper)from
thejunctionbox,locategroundscrew(E)onmountingstrap
(A)andwrapthexturegroundwirearoundthegreenground
screw(E).Useascrewdrivertosecuregroundscrew(E)onto
themountingstrap.Tuckallwiresneatlyintothejunctionbox.
Bottom View of 6 LT
View of 4 LT
View of 6 LT
  • Page 1 1

Golden Lighting 2360-4 CH Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI