Page is loading ...
Quick Installation Guide
iS216
GbE iSCSI to SATA II/III Chassis
Rev. 111011
1
CONFIG IP CAMERA
• 32 IP Cameras with IP Address: 192.0.0.xx
• 32 IP Cameras with IP Address: 192.168.0.xx
CONFIG NETWORK ON DVR SYSTEM
• Network 1: Connect DVR to Switch
2
• Network 2: Connect DVR to Switch
• Network 3: Connect DVR to iSCSI
3
• Network 4: Connect DVR to iSCSI
4
• Add to Bridge: Select Network3 and Network4. Right-click Æ Bridge Connections
• Config Network Bridge:
Right-click Network Bridge Æ Properties
5
Set IP Address for TCP/IPv4
6
CONFIG iSCSI (Using Web GUI)
CONFIG NETWORK ON iSCSI SYSTEM
• After you turn on the iS216, there will be an IP address (e.g. 192.168.xxx.xxx) shown
on the LCD on the rear of the iS216 enclosure.
• Open a web browser (Internet Explorer…etc.), and key in the IP address shown on
the LCD into the web browser and press Enter.
• The entry screen of the web GUI will be shown. Key in the default user name and
password. The default user name is: admin, and the default password is: 1234,
and then press Login.
• Select iSCSI configuration on the left menu Æ NIC
7
• The settings for NIC 1 IP address config
• The settings for NIC 2 IP address config
8
CONFIG RAID
METHOD 1: QUICK INSTALLATION
• 1) Connect to Web GUI 2) Select Quick Installation Æ on the RAID level
drop-down list, select RAID6. Click Confirm to continue
• Click Confirm to continue
9
• Click the option button in virtual disk No. field. Select Attach LUN
• Input Host (iSCSI node Name):
+ “*”: to allow all machines to use this iSCSI system
+<Initiator Name>: single machine with name <Initiator Name> can use this iSCSI
system.
• Click Confirm
10
Note: Click Start Menu Æ Control Panel Æ Administrative Tools Æ iSCSI Initiator
Æ tab Configuration to get “Initiator Name”
Setup is complete.
11
METHOD 2
• Connect by Web GUI. Select Volume Configuration on left menu Æ RAID group
• Input Name Æ on RAID level drop-down list select RAID 6 Æ Click the Select PD
Button
12
• Check all disks. Click Confirm to confirm the selections.
• Click Next to continue
13
• Click Confirm
• Click Create to finish configuring the RAID group
14
15
• Click Virtual disk on the left menu Æ Click the Create button
• Enter a Name for the virtual disk
• A dialog box will appear. Click OK
• Click the option button in virtual disk No. field. Select Attach LUN
16
• Click Confirm
Setup is now complete
17
ATTACH iSCSI STORAGE TO DVR SYSTEM
• Go to Start Menu Æ Control Panel Æ Administrative Tools Æ iSCSI Initiator
18
• Select the Discovery tab
• Click Discover Portal. A dialog box will appear. Enter IP and Port of NIC1
19
/