Page is loading ...
RF CCT Controller 09.283CT.04337
Note:Before the first use, please remove the protective film on the battery.
Function introduction
Important: Read All Instructions Prior to Installation
Output RF signal
Operation Frequency 868/915/434MHz
Operating temperature 0-40°C
Relative humidity 8% to 80%
Dimensions 136.3x38.9x10.7mm
Front side
Back side
• Control 4 zones of RF receiver
• Dual color controller
• Compatible with universal serie RF receiver
• 1 receiver can be paired by max 8 different remote controls.
• Waterproof grade: IP20
Product Data
• This device contains a button lithium battery that shall be stored and disposed properly.
• DO NOT expose the device to moisture.
Safety & Warnings
Power Supply 3V(1xCR2025 battery)
Control the receiver's cw channel,
Press and hold down to increase/
decrease light intensity
4 zones, click to choose a zone,
press and hold down to turn ON/OFF
corresponding zone
Control the receiver's ww channel,
Press and hold down to increase/
decrease light intensity
On/Off
Press and hold down to increase light
intensity smoothly
Press and hold down to decrease light
intensity smoothly
Click to play/pause running mode from
Warm White to Cool White
Press and hold down to save color/
scene, click to recall the saved
Step 3:Choose and click a zone number(e.g. zone 4)
Step 2:
three times continuously to set it into pairing status
Click the “Learning Key” button on RF receiver or re-power on the receiver
Note: one receiver can be paired with max 8 remote controls.
Learning Key
RF LED Receiver
Step 1:Do wiring the RF receiver according to wiring diagram(please refer to the
instruction of RF receiver that you would like to pair with.
Step 4:Click any of the four buttons (e.g. ), LED lights connected
with the RF receiver flicker once means the receiver is paired with zone 4 successfully.
Pair with RF receiver
Click the paired zone number/numbers, then click the other buttons to do the controlling
Operate the remote after pairing
If you use multiple receivers, you have two choices:
Option 1: have all the receivers in the same zone, like zone 1
Lear ning K ey
RF LED Re ceive r
Zone 1
Option 2: have each receiver in a different zone, like zone 1, 2, 3 or 4
Zone 1 Zone 2 Zone 3
RF remote
RF remote
Lear ning K ey
RF LED Re ceive r
Lear ning K ey
RF LED Re ceive r
Lear ning K ey
RF LED Re ceive r
Lear ning K ey
RF LED Re ceive r
/
