ARRI TRINITY 2 - Pairing with RF-2400 Radio Modules User manual

  • I have reviewed the user manual for the ARRI TRINITY 2 RF-2400 Radio Module. This document provides instructions on how to pair the RF-2400 radio modules using the Remote Control Panel RCP-3. It also specifies the importance of using the Rubber Duck antenna on the module located in the TRINITY 2 head to prevent tilt movement blockage. I'm ready to answer your questions regarding this device.
  • How can the RF-2400 Radio Modules be paired?
    What type of antenna should be used on the radio module located in the TRINITY 2 head?
    Why is it important to use a rubber duck antenna?
RF-2400 Radio Module Pairing Guide
For ARRI TRINITY 2 SUP 1.4
U S E R M AN U A L
April 2023
Pairing the TRINITY 2 RF-2400 Radio Modules 2
1 Pairing the TRINITY 2 RF-2400 Radio Modules
ADVICE
Both RF-2400 Radio Modules can only be paired through the Remote Control Panel RCP-3.
Power up and switch on the RCP-3
Insert the first RF-2400 Radio Module
Go to the Main Menu.
Tab Radio Setup
Tap Pairing
Pairing the TRINITY 2 RF-2400 Radio Modules 3
After a short time, you will be asked to remove the first module and
insert the second module.
So, remove the first radio module and insert the second module.
Insert the second radio module.
Again, after a short time, the information appears that the second
module has also been paired.
Now you can plug the first module into the radio adapter on the
TRINITY 2.
ADVICE
Be sure to use the Rubber Duck antenna on the radio module lo-
cated in the TRINITY 2 head.
The standard antenna will block the tilt movement of the tilt axis!
/