RetroSound Antenna Owner's manual

RetroSound
Brand
RetroSound
Model
Antenna
Type
Owner's manual
Spacers
Antenna CableMain Antenna Insert
1. Thread the antenna cable onto the bottom of the main antenna insert.
INSTALLATION INSTRUCTIONS
2. Place the spacer(s), if needed, onto the main antenna insert from the top.
Rubber Gasket Slant Bezel
Rocker
Fender
3. Place the rocker, with the round side down and teeth side up, onto the main antenna insert.
Then place the antenna assembly through the antenna hole from the underside of the fender.
4. Once the antenna assembly has been placed through the antenna hole,
place the rubber gasket and slant bezel over the main antenna insert from the top.
Fender
Fender
INSTALLATION INSTRUCTIONS (continued)
Main Antenna Insert Antenna Nut
5. Thread the antenna nut onto the top of the main antena insert. Do not overtighten.
NutAntenna AdapterAntenna Mast
6. Thread the antenna adapter into the bottom of the antenna mast. The fine threads go into the mast.
Then thread the nut onto the end. Do not over tighten.
Fender Fender
INSTALLATION INSTRUCTIONS (continued)
7. Thread the antenna mast into the top of the main antenna insert. Do not overtighten.
www.retromanufacturing.com
[email protected] | 888.325.1555
Finished Installation
Antenna Mast
Fender
Fender Fender
Main Antenna Insert
INSTALLATION INSTRUCTIONS (continued)
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

RetroSound Antenna Owner's manual

RetroSound
Brand
RetroSound
Model
Antenna
Type
Owner's manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents