Kmart 42890232 User manual

JUMPING BALL

Keycode: 42890232

We thank you for purchasing this toy and we recommend that you read the instructions before playing.

Parts list

Jumping board x 1 pce Jumping ball x 1 pce Pump with needle x 1 pce

Assembly Instruction

Step 1: Place the needle into the pump, then insert the needle into the hole of the ball vertically to inflate it

(see image 1).

Step 2: Put the jumping board on the ball while the ball is about 40% inflated. Ensure the upside of the board and the

needle hole is in same direction (see below image 2) and the board bottom is attached on the upside of the

stopper on the middle of the ball (see below image 3).

Step 3: Continue to inflate the ball and adjust the board position whilst inflating to ensure the board attaches to the

stopper on the middle of the ball. Pull out the needle of the pump after inflation is finished and the jumping ball

is then assembled successfully (see below image 4).

Image 1 Image 2 Image 3 Image 4

Warning:

. Adult supervision is required when using the jumper.

. Maximum user weight: 50kg.

. Always make sure the inflatable ball is fully inflated. Use only the provided manual hand pump. Don't use an electric

pump or compressor.

. Never use your jumping ball without shoes.

. Proper protective equipment is recommended for use. (Helmet, knee & elbow pads and wrist guards).

. Only use your jumping ball in a safe area that is free of any obstacles. Only use your jumping ball on dry, smooth, flat,

paved or grassy surfaces. Don't use your jumping ball in or near roadways, irregular, uneven, wet and slippery surfaces,

or any other potentially hazardous area.

. Never attempt to have more than one person on the jumping ball at a time.

. Don't attempt " tricks " beyond your skill level.

Made in China