Assembly of your Sky Board. Should be performed by an adult.
Remove all Sky Board parts from the box. Carefully inspect for any damage. Replace any damaged or missing parts ONLY with
genuine b4ADVENTURE parts. You need a
manual air pump and some petroleum jelly.
Step 1-Attach the inflation needle to your pump. Coat
the needle tip with a little petroleum jelly. Carefully
insert the inflation needle halfway into the ball valve. Slowly pump the ball 5 times, this will help seal the needle for final
inflation and partially inflate the bounce ball for correct positioning in the Sky Board.
Step 2-Place the partially inflated ball inside the board with the inflation ball valve on top of the board-Fig. 1. Align the middle
Rib section so that when inflated, it will be on the bottom side of the board-Fig. 2 and 3. Take your Inflation guide and place it
over the bottom ball. Using your manual air pump, fully insert your needle and pump the bounce ball until the bottom ball
fits the curved section of your Inflation Guide-Fig. 4. You are now ready to use your Sky Board!
Step 3-Using a small, phillips screwdriver, remove the battery access door and insert
3 x AAA (1.5V) batteries. To activate board, simply push the black button on
the bottom of the board. NOTE: The lights will activate when the board is either
being used or is impacted and will remain on as long as used (will automatically
shut off when not in use, or if the batteries are drained). To avoid accidental
battery drain, simply press the switch again (off position).
NOTE: OVER TIME AND REGULAR USE, YOUR SKY BOARD WILL REQUIRE FREQUENT ADDITIONAL
INFLATING-KEEP YOUR INFLATION GUIDE CARD AND HAND/FOOT PUMP WITH YOU DURING USE.
Using your Sky Board
• Grip both your hand grips, and then carefully place your other foot on the other side of
the board/ball-Use Caution!-start balancing and start with small bounces.
TIP: At first, to make it easier to balance you can let a small amount of air out of the ball (allow a one to a two
second burst of air out the ball with your inflation needle).
• As you get better, use caution and common sense when jumping/bouncing on your Sky Board.
• Don’t attempt tricks that are dangerous or beyond your ability. HAVE FUN!
Maintenance Checklist -
Before each use:
• Clean your board. Do not use any harsh chemicals! Clean with a towel and warm water only! Dry completely before
using. Remove batteries during storage.
• Use your inflation guide to check ball air pressure.
• Inspect for any damage (cracking/splitting), fraying on the bungee cords, or for ball not inflating properly: DO NOT
USE if any damage is found.
• DO NOT MODIFY OR PUT ANYTHING ON YOUR SKY BOARD THAT ALTER ITS ACTION/OPERATION.
For questions or ordering contact: b4Adventure.com or email us at: Info@b4adventure.com
Save these instructions in case you need to contact the Manufacturer.
BATTERY WARNING!-BATTERY USE AND HANDLING PRECAUTIONS
Battery acid leakage can cause severe injury to people and cause significant damage to the product and to
property that comes into contact with it. If battery leakage occurs, wear hand and eye protection and wash
with water and baking soda (if available) and make sure to not get any acid on you or your clothing. If your get
acid on your clothing, wash them immediately or damage may occur. If you get acid on your body, rinse with
water immediately and seek medical attention. Dispose batteries according to Local, State or Federal Laws.