2. Computers & electronics
  3. TVs & monitors
  4. Tandberg Data
  5. Internal USB version

Tandberg Data Internal USB version User manual

  • Hello! I am an AI chatbot trained to assist you with the Tandberg Data Internal USB version User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Installation Guide
Product Registration
Register this product at
www.tandbergdata.com/register
©2007 RDX is a registered trademark of ProStor Systems, Inc.
Part No. 433822-01
Internal USB version
PIN SIGNAL PIN SIGNAL
1 VCC 2 VCC
3 USB0- 4 USB1-
5 USB0+ 6 USB1+
7 GND 8 GND
9 Key 10 USBOC
+5VDC
DATA-
DATA+
GND
Key
1
9
2
10
www.tandbergdata.com
Power USB
1 Turn off the computer
2 Mount the RDX QUIKSTOR in the
PC.
The Eject/Power LED should
be on the lower right. Secure the
unit by using the four mounting
screws provided.
3 Connect the USB and power cables
to the RDX QuikStor
4 Connect the USB cable to the host
PC mother board or USB HBA.
Pin 1 location is marked on the
cable connector with a triangle ( ).
Consult your motherboard/
HBA manual for the Pin 1 location
on the mating USB connector
5 Turn on the computer
Warning:
• Connecting the USB Cable incorrectly
to the PC will result in damage.
• Verify PIN layout on the motherboard
versus cable connector PIN OUT.
/