Setup of an e-mail account in the display
The following steps explain how to set up your email account in the frogDisplay.
Step 1:
Activate the SMTP server and enter your e-mail, user
name and password.
The data for your SMTP server (outgoing mail) - such
as host name or port - can be found at your
respective provider.
Encryption via TLS/SSL is recommended.
Step 2 :
After completing all entries, you can send a test mail
to check whether your account details have been
entered correctly. This mail will then be sent to the
registered mailbox.
Depending on the email provider, separate
verification may be required (two-factor authenti-
cation).
Example: the Gmail SMTP server
praxistipps.chip.de wrote on 12.08.2016:
"If you receive your mails via POP3, use the address "pop.googlemail.com" (port 995) as
incoming mail server. For outgoing mail use "smtp.googlemail.com" (port 465 or 587). For
reception via IMAP, use the address "imap.gmail.com" (port 993). The outgoing mail server
also changes to "smtp.gmail.com" (port 465 or 587). Note: For the incoming mail, select the
standard SSL as encryption." (Aschermann, T., 12.08.2016, Gmail: Set up incoming mail server
and outgoing mail server, https://praxistipps.chip.de/gmail-posteingangsserver-und-
postausgangsserver-einrichten_49178, retrieved 14.02.2022)
