13 February, 2012, www.brodit.com, © 2012 Brodit AB
Product 511288
511288 Passive holder with tilt swivel
When keeping your BlackBerry in a passive holder, it is always within easy reach. A portable handsfree or a
charging cable can be connected to the device when it is in the holder. The holder is attached onto a tilt swivel
and can be adjusted in order to avoid light reflection. Attach onto a ProClip Mounting Platform.
EAN: 7320285112889
Item no 511288 fits:
BlackBerry Torch 9850
BlackBerry Torch 9860
1(2)
1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please, carefully read all instructions and review the pictures before attaching the holder.
1. Unscrew the screw in the center of the holder. Remove the holder from the tilt swivel base plate.
2. Place the base plate onto the desired position. Screw the base plate into place by using the enclosed screws.
3. Start to thread the center screw into the base plate. When you connect with the nut, pull the holder towards
you to prevent the nut from spinning around. Tighten the screw firmly. Then loosen the screw sligthly for easier
angling/rotation of the holder.
4. The holder is in place. Slide the device into the holder. To remove the device from the holder, slide it out. Use
the tilt swivel to adjust the angle, or rotate the holder into a horizontal/landscape position if desired.
2(2)
/